How do marine engines reduce fuel consumption?

How do marine engines reduce fuel consumption?

7 Technologies To Reduce Fuel Consumption Of Ships

1. Air Lubrication.
2. Fuel Saving Propeller Attachment.
3. Onboard DC Grid System.
4. Low Loss Hybrid Energy System.
5. Nose Job – Modifying Ship’s Bulbous Bow.
6. Fuel Oil Emulsion (FOE) technology.
7. Wind and Solar Power.

How do you calculate the specific fuel consumption of a marine diesel engine?

SFOC (g/kwh) = Mass of fuel consumed per hour / Power developed in KW

1. The readings of the flow meter to the main engine should be noted over the specified time interval say 1 hour.
2. The mass of the observed volume of fuel consumed can be determined by following the above-said bunker calculation procedure.

How do you calculate fuel consumption for a ship?

Measuring and Reporting Fuel Oil Consumption The formula (Corrected Density = Density at 150C X [1 – {(fuel temp (0C) – 150C) X 0.00065}]) should be used to obtain the corrected density at the recorded fuel temperature. A calculation table has been provided for this purpose in the excel worksheet.

Does fuel consumption rises with increasing vessel speed?

In addition to increases in speed, resistance and fuel consumption increase by any of the following three parameters [2]: Increased draft and displacement. First, when fuel efficiency and CO2 emission are of concern, the fuel consumption is more important to be calculated than the engine power.

What is the most fuel efficient ship?

The Triple-E is the world’s largest and most efficient vessel. The vessel reduces emissions and fuel consumption through the combination of its two engines, efficient shape and an advanced waste heat recovery system.

How can I improve my boats fuel efficiency?

How To Save Fuel While Boating

1. Tune your engine. Take your engine to the shop once a year for a tune-up and service, which helps it run more efficiently.
2. Get the right propeller.
3. Check your propeller.
4. Clean your hull.
5. Measure your fuel flow.
6. Upgrade your motor.

How can fuel consumption in vehicles be reduced?

Techniques and Technologies for fuel reduction of vehicle. The ITS techniques and technologies can reduce energy consumption by changing the driving behavior, suggesting congestion free smooth path, automatic traffic control signal, electronic toll collection, and platooning.

Are ships fuel efficient?

New ships are on average less fuel-efficient than those built in 1990, according to the first ever study of the historical development of the design efficiency of new ships.

What is the cubic law of marine engineering?

Curves 3 and 5 on the grid, the propeller power and propeller fuel consumption curves, are based on the so-called cubic law of marine engineering. Simply stated, the power required to turn the propeller varies with the rpm, roughly to the cube (i.e., an exponent of 3) of the ratio between any two rpms.

What are the curves on a boat engine?

The scale on the lower right refers to the lower set of curves numbered 4 and 5, labeled “Fuel Consumption” and “Fuel–Propeller Load,” and measures how much fuel the engine burns in gallons per hour. The upper curve (4) is how much the engine would burn if it were pulling full power throughout its rpm range, but it’s not.

How is fuel consumption related to speed curve?

Factors affecting ship’s fuel consumption Typically a ship’s power vs. speed curve is prepared during the delivery sea trials. Power is a more stable parameter compared to fuel consumption and hence easier to be measured.

How much does a 10% speed reduction reduce fuel consumption?

As a rule of thumb assuming that engine power follows the cube of speed, a displacement ship with 10% speed reduction reduces the power need (resistance) and coherent fuel consumption by 27%.

The scale on the lower right refers to the lower set of curves numbered 4 and 5, labeled “Fuel Consumption” and “Fuel–Propeller Load,” and measures how much fuel the engine burns in gallons per hour. The upper curve (4) is how much the engine would burn if it were pulling full power throughout its rpm range, but it’s not.

As a rule of thumb assuming that engine power follows the cube of speed, a displacement ship with 10% speed reduction reduces the power need (resistance) and coherent fuel consumption by 27%.

Curves 3 and 5 on the grid, the propeller power and propeller fuel consumption curves, are based on the so-called cubic law of marine engineering. Simply stated, the power required to turn the propeller varies with the rpm, roughly to the cube (i.e., an exponent of 3) of the ratio between any two rpms.

Factors affecting ship’s fuel consumption Typically a ship’s power vs. speed curve is prepared during the delivery sea trials. Power is a more stable parameter compared to fuel consumption and hence easier to be measured.