How do I turn my power liftgate back on?
How do I turn my power liftgate back on?
The PWR DOOR OFF switch in the glove box must be in the ‘operate’ position for the liftgate to be operated in power mode. To open the liftgate using the switch on the instrument panel, press and hold the switch until you hear a tone and the liftgate opens. To stop it, press again. To close it, press and hold.
Why does my liftgate not close from open position?
If DTCs B153E or B396A are set, the cause may be that the male terminals in the body harness 10-way in-line connector to the liftgate power assist actuator may not be dimensionally stable or may be misaligned, causing intermittent electrical contact. (Fig. 12) Fig. 12
When does the liftgate stop on an equinox?
The power liftgate may stop when opening from the fully closed position (usually opening not more than 15 inches, or 38 cm) or will not close from the open position on some 2018-2019 Equinox and Terrain models.
Where is the liftgate assist actuator connector located?
Lower the left rear portion of the headliner to access the body harness to liftgate assist actuator connector. (Fig. 13) Inspect the body harness male in-line connector for any bent or misaligned terminals. (Fig. 14) Straighten any misaligned terminals and reconnect the connectors.
What is the DTC for the power liftgate?
DTCs B153E (Liftgate Position Sensor Signal Circuit), B153F (Liftgate Object Sensor Signal Circuit) or B396A (Left Liftgate Motor Control Circuit) may be set in the power liftgate module.
Are there any problems with the liftgate on a GMC Acadia?
Make and Model > GMC Trucks > Acadia > Power liftgate problems on… GM has issued a service bulletin to address power liftgate problems on Enclave, Traverse, Acadia, and Outlook vehicles listed below. GM has documented the following power liftgate problems and their causes
How to disable the power liftgate on a GM car?
1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack. Manually open the liftgate to the full open position using the exterior liftgate pull handle.
Are there any problems with the liftgate on the GM enclave?
GM has issued a service bulletin to address power liftgate problems on Enclave, Traverse, Acadia, and Outlook vehicles listed below. GM has documented the following power liftgate problems and their causes
If DTCs B153E or B396A are set, the cause may be that the male terminals in the body harness 10-way in-line connector to the liftgate power assist actuator may not be dimensionally stable or may be misaligned, causing intermittent electrical contact. (Fig. 12) Fig. 12
