How do I time a New Holland 273 square baler?
How do I time a New Holland 273 square baler?
Grab hold of this rod down where it connects to the needle yoke and give it a pull towards the rear of the baler. It should come back a little. If you do not do this, it will be out of time. The next step is to check and see if the timing marks line up. If not, then remove the chain
Where is the timing chain on a New Holland Baler?
The opposite end of the feeder bar hangs on an arm on the right side of the access and there should be 2 holes in the steel behind the arm and you will need to line those up as well. Once you have those three spots line up, you will just refit the feeder drive chain, and re-tension that and the timing chain which is accessed from the front.
Where do the timing marks go on a New Holland tractor?
If it is in home position and your marks are still lined up then advance chain going to the knotters until the needles enter the bale chamber at 3/4 of an inch behind the plunger face. This is the correct deminsion if balers do not have any timing marks.
How much pressure do you put on knotters on New Holland 273?
Adjustment on knotters is on the drive chain on the left side, make sure the feeder chain is tight, my 282 calls for flex of 5/8 inch with 100 lbs pressure midway between sprockets (really tight). Good luck with the baler they are good ones. Thanks for your help Dan. I am still having pin shearing trouble at the fly wheel.
The opposite end of the feeder bar hangs on an arm on the right side of the access and there should be 2 holes in the steel behind the arm and you will need to line those up as well. Once you have those three spots line up, you will just refit the feeder drive chain, and re-tension that and the timing chain which is accessed from the front.
What’s the best way to time a New Holland hay baler?
To time it roll the flywheel to where the plunger crank is straight up, go in the normal direction of travel and works best with chamber clear of hay. There shoud be 2 chissel marks on the rail next to the plunger case.
If it is in home position and your marks are still lined up then advance chain going to the knotters until the needles enter the bale chamber at 3/4 of an inch behind the plunger face. This is the correct deminsion if balers do not have any timing marks.
