How do I fix code P0625?
How do I fix code P0625?
Depending upon the diagnosis, common repairs for this code include:
- Replacement of damaged electrical components (blown fuses)
- Replacement of control module ground strap.
- Disconnecting of CAN pins and testing them (this can be an expensive and challenging step, and should be done last)
What does code P0625 mean?
generator field control circuit
P0625 code definition When code P0625 is stored it means that a problem in the generator field control circuit has been detected by either the PCM or a supporting control module.
What is P0626?
The P0626 code is the OBD-II generic code for a fault that is detected on the generator field circuit. This is most likely due to a faulty alternator or generator control module. Other modules within the OBD-II system can detect this fault aside from the powertrain control module.
What is a generator field control?
[′jen·ə‚rād·ər ′fēld kən‚trōl] (electricity) Method of regulating the output voltage of a generator by controlling the voltage which excites the field of the generator.
What is generator field duty cycle signal?
The generator provides a feedback signal of the generator voltage output through the generator field duty cycle signal circuit to the PCM/ECM, this information is sent to the body control module (BCM). The signal is a PWM signal of 128 Hz with a duty cycle of 0–100 percent. Normal duty cycle is between 5–99 percent.
What five 5 steps should you follow while inspecting a charging system?
If any of these symptoms are evident, then follow these five steps to pinpoint the issue:
- Perform a visual inspection under the hood. Look at the belt tension andcondition.
- Visually inspect and test the batteries.
- Measure system voltage.
- Test alternator output.
- Troubleshoot using the service manual.
What does it mean when code p0625 is stored?
When code P0625 is stored it means that a problem in the generator field control circuit has been detected by either the PCM or a supporting control module. This code means that something has gone wrong with the generator field control circuit.
How much does it cost to repair Ford p0625 code?
The cost to diagnose the P0625 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What does p0625 Ford mean in Powertrain Control Module?
| P0625 FORD Meaning The powertrain control module (PCM) monitors generator load from the generator/regulator in the form of frequency. The concern indicates the input is lower than the load should be in normal operation. The load input could be low when no generator output exists.
What are the coils and stator in p0625?
Note that the part labelled “Stator” is a metal ring that holds copper windings in place; the field coils are the sets of copper wire windings that protrude from both sides of the stator, or metal ring. What are the common causes of code P0625?
