How are the wires attached to an indicator stalk?
How are the wires attached to an indicator stalk?
Refer to the wiring diagram in your service manual to identify the indicator wires. There are usually three wires attached to the indicator switch: one feed wire to the switch and two wires leading from it to feed the right- and left-hand circuits . Look carefully to make sure none of the wires has fallen off or broken.
Do you need to remove steering column shroud to fix indicator stalk?
Before carrying out any work on the stalk disconnect the battery leads as a safety precaution against short circuits . On the majority of cars you have only to remove the steering column shroud to gain access to the indicator stalk switch mechanism. But in some cases you will also have to remove the steering wheel (for details see Projects 2).
How do you disconnect an indicator stalk on a car?
Before carrying out any work on the stalk disconnect the battery leads as a safety precaution against short circuits . On the majority of cars you have only to remove the steering column shroud to gain access to the indicator stalk switch mechanism.
What do you need to know about an indicator switch?
You should now be able to see the indicator stalk switch. The stalk may perform other functions apart from operating the indicators, in which case you will find several wires leading to it. Refer to the wiring diagram in your service manual to identify the indicator wires.
Do you need to know what’s inside your steering column?
GM rebuilding, Ford upper bearing problems, broken shift levers, loose steering wheels, broken Dodge & Jeep ignition actuators are just some of the detailed instructions we offer in step-by-step instructions for you to follow and repair your steering column yourself. Do you need to know what’s inside your steering column?
Where is the ignition switch on a GM tilt steering column?
The ignition switch bolts to the column with a 5/16″ stud-headed screw. Install the screw finger tight at this time, note the slots that allow the ignition switch to be adjusted up or down the column: We’ll adjust the ignition switch later, after the column is fully assembled. Inside the GM Tilt Steering Column Page 16
How is the tilt of the steering column maintained?
The tilt adjustment is maintained by toothed pawls that engage the pins in the top of the lower housing. When the tilt release lever is pulled it releases the pawls and allows the upper column to pivot up and down on the tilt pivot pins.
