Do sealed ball joints need grease?
Do sealed ball joints need grease?
Most manufactureres use sealed ball joints that do not come with grease zerk fittings. Theoretically, these ball joints will not need any extra grease and are sealed up tight so contaminates can’t get inside, but if you notice a groaning while turning then the culprit might be a grease-thirsty ball joint.
How to grease a sealed ball joint-YouTube?
But since they are sealed, many people pay the added cost of having the parts replaced. In this video, I want to show you how to extend the life of the seal joints so you can get the most out of your suspension. With the use of a Grease Needle, you can add some grease to your joints with ease. Loading…
What’s the best way to clean a ball joint?
The grease zerks on many vehicle’s ball joints are almost impossible to connect to directly, even with a mini grease gun. Save the frustration and use a hose. Rag – To clean the zerk and wipe excess grease away. This will A) keep dirt and debris from collecting around the joint and B) allow any leakage to show up more quickly later down the road.
Can a Zerk needle be used to grease ball joints?
You can use a grease zerk needle attachment to get past the dust boot and pump some grease into that ball joint. This can eliminate those noises and potentially extend the life of the part, but this method will almost certainly not grease the entire part. As a stop-gap measure this should stretch the life span of your ball joint.
How do you Grease a tie rod with no grease fittings?
If you need to grease a ball joint or tie-rod end and it has no grease fitting, there is a way to grease the non-greaseable joints. What to use is a needle adapter on the grease gum. The needle adapter can get grease into almost any area that a typical grease gun can not reach.
What’s the best way to grease a ball joint?
Rag – To clean the zerk and wipe excess grease away. This will A) keep dirt and debris from collecting around the joint and B) allow any leakage to show up more quickly later down the road. DST offers these tools (minus the rag) in a Grease Gun Combo for your convenience. 1. First, you should inspect the dust boot for leaks.
What happens when you lubricate a sealed ball joint?
Also, lubricating the joint will destroy the boot due to the pressure of the grease gun. The tight tolerances inside the sealed joint do not provide much room for additional lubricant. Forcing grease into the joint may damage the existing sealing surfaces, leading to accelerated loss of lubricant.
What do you put in a ball joint to make it run?
If not, it may take quite a few pumps. Fill the ball joint with enough grease to expand the rubber boot. If you notice some grease starting to purge through the rubber boot, there’s enough grease in the ball joint.
If you need to grease a ball joint or tie-rod end and it has no grease fitting, there is a way to grease the non-greaseable joints. What to use is a needle adapter on the grease gum. The needle adapter can get grease into almost any area that a typical grease gun can not reach.
