Can a cat set off a motion sensor?
Can a cat set off a motion sensor?
If a cat is able to get directly in front of a motion sensor, it will still activate, regardless of any pet-immunity rating. But by installing a motion sensor in a proper location and at a proper height, it will be nearly impossible for this to happen. For more information, please review this FAQ on where to install motion sensors.
Is it normal for a cat to pass gas?
Do cats pass gas, too? The answer is yes. Cats do get gas. Like many other animals, a cat has gases inside its digestive tract, and this gas leaves the body via the rectum. Cats usually pass gas quietly and there isn’t much odor to it. However, sometimes cats can have excessive bloating, discomfort, and bad-smelling gas.
How is the adaptive numerator used in the PCM?
The Adaptive Numerator is a software learning routine that tells the PCM where the crankshaft slots are. Since every crankshaft is different, the POM must learn exactly where its particular crankshaft slots are; otherwise its RPM calculations would be wrong.
If a cat is able to get directly in front of a motion sensor, it will still activate, regardless of any pet-immunity rating. But by installing a motion sensor in a proper location and at a proper height, it will be nearly impossible for this to happen. For more information, please review this FAQ on where to install motion sensors.
Do cats pass gas, too? The answer is yes. Cats do get gas. Like many other animals, a cat has gases inside its digestive tract, and this gas leaves the body via the rectum. Cats usually pass gas quietly and there isn’t much odor to it. However, sometimes cats can have excessive bloating, discomfort, and bad-smelling gas.
The Adaptive Numerator is a software learning routine that tells the PCM where the crankshaft slots are. Since every crankshaft is different, the POM must learn exactly where its particular crankshaft slots are; otherwise its RPM calculations would be wrong.
How does a motion detector work for pets?
Small pets and the Motion Detector settings The Ring Alarm motion detectors use Passive Infrared sensors (PIR) to scan whatever room they’re placed in. These detectors use heat to detect motion in the room and when a warm body like a human or animal passes in the area it is monitoring (its field of view) the sensor detects the change.
Why are the cam and crank sensors on my Cat not working?
I replaced both sensors with new cat sensors. Probably was still there. So then I took apart the harness that holds the 2 sets of wires going to the 2 sensors. I found the wires were destroyed from oil contaminants and wires were out of the plastic and all green and corroded.
Where is the O2 sensor after the cat converter?
If the catalytic converter is doing its job properly, the downstream O2 sensor, located AFTER the cat converter, should rarely switch between rich and lean. If it does toggle between rich and lean, the sweep should be fairly mild.
If the catalytic converter is doing its job properly, the downstream O2 sensor, located AFTER the cat converter, should rarely switch between rich and lean. If it does toggle between rich and lean, the sweep should be fairly mild.
I replaced both sensors with new cat sensors. Probably was still there. So then I took apart the harness that holds the 2 sets of wires going to the 2 sensors. I found the wires were destroyed from oil contaminants and wires were out of the plastic and all green and corroded.
How does a cat converter work in a car?
A cat converter is designed to store excess oxygen and use it to burn off excess fuel, oil, coolant that comes into the cat. If there’s too much fuel coming into the cat, you wind up with a run away condition where the temp gets so hot that it melts the ceramic brick, totally clogging the exhaust and rendering the cat useless.
