Can a 57-64 rear end be converted to Posi?
Can a 57-64 rear end be converted to Posi?
THIS IS WHERE A MODIFICATION IS REQUIRED FOR THE 57-64 NON-POSI CASE BEFORE A POSI UNIT CAN BE INSTALLED. A portion of this gusset must be removed to provide clearance for the posi unit, and it does not matter if an original factory style posi is used or an aftermarket posi unit such as the Eaton is used.
How to change the rear end of a Chevy Silverado?
I am looking to change the rear end on my chevy to a posi. I removed it this morning. I am now looking for a new rear end to put in. Does anyone know the code for a posi rear end that will fit? Also I am thinking to change the ratio, because it has big wheels and eventually the motor will have a blower on it.
Are there any Chevy gears that are Posi?
The original Chevy gears are excellent quality and there is no reason to not re-use them. This is also the new Eaton posi unit, all new bearings, crush sleeve and pinion seal. The first thing is to drive in the new pinion races.
Can a Chevy 10 bolt differential be disassembled?
The disassembly procedure for both Chevy 10- and 12-bolt rear differentials is virtually the same. You do not need to be concerned with getting it out of alignment.
How many gears does a Chevy Posi have?
12 bolt Chevy POSI 4.10 GEARS 4 SERIES TRUCK 4X4 2WD 1500 C10 PINION RING CLEAN! NEW CURRIE 55-59 CHEVY TRUCK REAR END,6 LUG AXLES,BEARINGS,9″ FORD,3100,3200,ETC (Fits: Chevrolet Truck) Only 1 left!
THIS IS WHERE A MODIFICATION IS REQUIRED FOR THE 57-64 NON-POSI CASE BEFORE A POSI UNIT CAN BE INSTALLED. A portion of this gusset must be removed to provide clearance for the posi unit, and it does not matter if an original factory style posi is used or an aftermarket posi unit such as the Eaton is used.
Can a 55-64 corvette be converted to Posi?
This article will be specifically directed at converting the 55-64 Chevrolet full size pass car and 56-62 Corvette NON-positraction rear end to positraction using an Eaton aftermarket posi unit. But, much of the information will be applicable to the original factory positraction units (originally made for GM by DANA).
What kind of paint to use on a posi rear end?
Often the stamped code and assembly date seen below is VERY difficult to find and usually requires thoroughly cleaning down to the bare cast iron. Painting is optional and your choice. Many early cases were painted a red oxide inside and outside, similar to that below.
