Are there any problems with the C6 transmission?

The C6 consists primarily of a torque converter, a planetary gear train controlled with a band, clutches and a hydraulic control system. The three-speed automatic was built with durability in mind, but problems can occur, particularly if the transmission has been improperly serviced or not serviced at all.

Why does my A6 C6 only work in 4th gear?

The car will drive forward in 4th gear only, and reverse will work. If the TR indicator doesn’t light up at all, there is an issue with the TCM. If none of the forward gears work but reverse does, you have a serious transmission problem that will probably require a rebuild (if you’re lucky) or replacement.

Why does my GMC TRA not go into gear?

If there is an issue with either of these the vehicle may experience problems shifting or transferring power to the wheels. If these are not the problem then it could be possible that the transmission is having internal faults, perhaps a worn torque converter, or transmission gears, inside of the transmission.

What should I do if my C4 transmission is not working?

If not, immediately shut off the engine and check the transmission fluid level. This Tech Tip is From the Full Book, HOW TO REBUILD & MODIFY FORD C4 & C6 AUTOMATIC TRANSMISSIONS. For a comprehensive guide on this entire subject you can visit this link:

Are there transmission issues in the Audi A6 C6?

One of which is the Audi A6 C6, a car that is so notorious for CVT transmission issues that it settled a lawsuit with around 64,000 folks. If you are one of the unlucky masses facing transmission issues with your A6, keep reading and we’ll walk you through the diagnostic process. Sometimes a simple service will correct the issue.

Why does my transmission not go into gear?

I put Lucas in the transmission because it was low on transmission fluid and was slipping in over drive then it stopped working at all after I put Lucas in it but when I first start it will go into gear and work fine until I get up the street then lose all gears how can I fix this My car has 268000 miles. My car has an automatic transmission.

What to do if your corvette won’t go into gear?

Corvette: Why Won’t My Car Go Into Gear? Transmission problems can leave you stuck at home unable to drive your Corvette. The good news is that manual transmissions are fairly straightforward, and with moderate skill and tools most concerns can be diagnosed and repaired.

How to disassemble Ford C4 and C6 transmissions?

You can use the social sharing buttons to the left, or copy and paste the website link: https://www.diyford.com/disassemble-ford-c4-c6-transmissions-step-step/ Dirty fluid is a transmission’s greatest enemy because it damages seals and causes excessive wear. And as fluid does its work, it deteriorates over time from heat and additive breakdown.

Is the C6 transmission used in drag racing?

The C6 transmission is very popular in the sport of drag racing today, with units equipped with manual valve bodies and transbrakes. It is also widely used in off-road applications due to its reputation of being nearly indestructible. The C6 was used in trucks and cars with larger engines.

When do you take the governor off a Ford C6?

The same can be said for a C6 with a screw-in throttle valve from 1966 to 1971, and then press-in from 1972-on. Pan and valve body are next, using a 1/2- inch socket for pan bolts and both 3/8- and 7/16-inch for valve body and filter. The tailshaft housing comes off next, using a 9/16-inch deep-well socket. Step-5: Remove Governor (Important!)

When did the Ford C6 transmission come out?

Ford’s C6 transmission was first produced in 1966 and was used primarily in trucks and for high-performance big block engines. The C6 consists primarily of a torque converter, a planetary gear train controlled with a band, clutches and a hydraulic control system.

Why is my C6 transmission not working properly?

If the transmission has recently been disassembled, the problem is likely a lack of fluid or a missing valve body ball. The C6 operates on hydraulic pressure, necessitating a sufficient amount of fluid.

What kind of transmission does a C6 Mustang have?

The transmission is a C6 however, according to CJ Pony Parts, the neutral safety switch I have is for an FMX transmission: https://www.cjponyparts.com/neutral-safety-switch-assembly-fmx-1969-1973/p/HW2951/ Neutral Safety Switch Assembly for 1969-1973 Mustangs with a FMX Automatic Transmission.

Are there any problems with the C6 transmission?