Why is my GM fuel pump not working?
Why is my GM fuel pump not working?
One of the things that can have you replacing a good fuel pump is an anti-theft system (PassLock) failure. How? This is due to the fact that when the Passlock system arms itself on your GM pickup or SUV, the engine will crank but won’t start, since the PCM has disabled the fuel injectors.
How to troubleshoot a no start GM 4.3L?
The following tutorial may be of help: How To Troubleshoot A No Start (GM 4.3L, 5.0L, 5.7L). CASE 3: The engine started and stayed running. This confirms that the fuel pump is starting to fail. The next step is to confirm the exact fuel pressure with a fuel pressure gauge to be absolutely sure.
How do you start a GM fuel pump?
Open the throttle plate, manually, and spray starting fluid down the bore. When you have sprayed a good squirt of starting fluid, quickly reconnect the air duct to the throttle body (you don’t have to tighten the fastener).
What’s the difference between no start and no crank?
It’s important to know that a no crank and a no start condition are not the same thing since this article only concentrates on testing a no start condition. In layman’s terms, a No Start Condition means that your vehicle’s starter motor is cranking the engine but the engine is not starting.
What causes a Chevy Astro van to not start?
In the Chevy Astro van, power is supplied to the fuel pump by the the gray wire on the electrical connector when the engine is being cranked. If power is supplied, hitting the fuel tank with the flat side of a hammer while someone else is turning the ignition key to start will sometimes bump the fuel pump enough to allow it to start.
Where is the fuel pump on a Astro van?
If it is good, check for power at the fuel pump electrical connector located near the rear of the fuel tank on the driver’s side of the van. In the Chevy Astro van, power is supplied to the fuel pump by the the gray wire on the electrical connector when the engine is being cranked.
What should battery voltage be in Astro van?
A measurement of 12.5 volts is considered discharged, and the battery should be charged before any further testing. Any measurement below 11 volts indicates a severely discharged battery–the battery is most likely damaged and should be replaced. If the battery measures above 12.7 volts, proceed to the next step.
Why does my GM 4.3L engine not start?
No Start Condition Basics There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start, it’s because one of these components is missing from the mix.
How much psi does a fuel pump need to start?
The fuel pump produces much more than just 50 PSI of course.. but the bare minimum the engine needs to start is 50 PSI… so anything less and it will crank for ever before it starts or not start at all.
How to check no fuel condition on GM 4.3L?
I’ve also included how to check a no fuel condition with starting fluid (although this is not the most effective way to test the fuel pump). It’s been my experience that misdiagnosing a bad fuel pump is a common occurrence on the 4.3L, 5.0L, 5.7L GM vehicles with the ‘Spider’ fuel injector assembly.
What causes a bad gas gauge on a Chevy truck?
A poor ground or loose connection to a gas gauge is just as likely to cause problems as loose or dirty battery cables assuredly will with your starting system.
What’s the fuel pressure on a 1998 Chevy k1500?
Here are the tests I’ve done so far fuel pressure test, fuel pressure 160psi while running, then shut off for 20 min and fuel pressure was at 155 PSI. Dry Compression test on all 8 cylinders between 150-160 psi.
Are there any Chevy Silverado 1500 fuel pumps left?
Only 3 left in stock – order soon. . Only 5 left in stock – order soon. . Only 15 left in stock – order soon. . . . Only 11 left in stock – order soon.
Can a 1997 Chevy c1500 5.7L start?
1997 Chevy C1500, 2WD, 5.7L won’t start – cranks fine. No codes – good fuel pressure ( 60+ psi – new pump), good spark, 1997 Chevy C1500, 2WD, 5.7L wont start – cranks fine. No… It will not start. I changed the fuel filter and fuel pump It will not start.
Can a Chevy C / K 1500 run without fuel?
Also I haven’t fully checked the Spark, but the Truck run’s fine when you spray Starting fluid into the Throttle body. Any suggestions on why the truck isn’t accepting the fuel, it cranks fine, just wont run without starting fluid. these trucks have to have between 55-65psi of fuel to run.
How can I tell if my fuel pump relay is faulty?
2. Engine does not start. Another symptom of a faulty fuel pump relay is an engine that does not start. If the fuel pump relay fails the fuel pump will be left without power. The engine may still crank when the key is turned, however it will not be able to start due to lack of fuel.
What to do if your suburban fuel pump goes out?
There are physical signs that you can feel when your Suburban’s fuel pump is going out. Before taking anything apart, check to see if your engine’s computer has any trouble codes saved in it. The engine may throw a P0087 trouble code.
One of the things that can have you replacing a good fuel pump is an anti-theft system (PassLock) failure. How? This is due to the fact that when the Passlock system arms itself on your GM pickup or SUV, the engine will crank but won’t start, since the PCM has disabled the fuel injectors.
Do you need to replace fuel filter when replacing fuel pump?
The fuel level sensor is a separate component attached to the fuel pump. This part does not always come with the fuel pump and sometimes is not interchangeable with aftermarket fuel pumps. Chevrolets have a common issue with fuel filters getting clogged. You always want to replace the fuel filter when replacing the fuel pump.
How can I tell if my fuel pump is damaged?
4. Damaged Fuel Pump. If you notice damage to your fuel pump, it may be caused by a restricted fuel filter. The clogged fuel filter puts too much pressure on the fuel pump and prevents the proper amount of fuel in the fuel tank from reaching the engine. Most fuel filters are relatively inexpensive and easy to change.
What causes a fuel pump to get clogged?
If you notice damage to your fuel pump, it may be caused by a restricted fuel filter. The clogged fuel filter puts too much pressure on the fuel pump and prevents the proper amount of fuel in the fuel tank from reaching the engine. Most fuel filters are relatively inexpensive and easy to change.