Why is my Chev k1500 350 Vortec not starting?
Why is my Chev k1500 350 Vortec not starting?
So I went and bought a sensor installed it and forgot to reset the computer before trying to start it. It changed nothing, still the same old problem. So I decided to reset the computer by disconnecting the battery, a good 10 to 15 minutes or so. Hooked it back up and still has the same problem.
What does it mean when your car says no start?
A No Crank Condition means that the engine is not turning over when you turn the key to crank the engine. The most common problem, that causes this condition is a failed starter motor. If your vehicle is suffering a No Crank Condition, this tutorial may be a good starting point: How To Test The Starter Motor (GM 4.3L, 5.0L, 5.7L).
Why does my car backfire when the starter quits?
Sometimes the backfire is a couple seconds after the engine quits turning. The engine was dead cold (never got it started) & it was like 35 degrees out. I will try & confirm tomorrow if I am getting spark while the starter is cranking. Also, the bad fuel theory has merit I suppose.
Why does my car not start when I turn the key?
This condition is usually due a failed fuel pump, a failed ignition coil, a failed ignition control module, a failed crank sensor, etc… that lets the engine crank (turn over) but does not let it start. A No Crank Condition means that the engine is not turning over when you turn the key to crank the engine.
What to do if your Chevy Silverado won’t start?
Change hole top of the motornew head gasket new intake preface vale seats new valve seals valve covergaskets new battery new belt plugs wires now it won’t start or even turn over what’s is my problem Truck won’t start and the alternator puts outs 14 volts . Turn keys nothing. It starts sometimes but not always . It start right away with a boost
Why does my Chev 350 Vortec not start?
Cold air is dense and spark goes through it harder. Give big ass GM gaps spark plugs and bingo, all secondary spark is crap. Guy came back today with his truck. Busted a brake hose, but he says gas mileage got better since tune-up and injector cleaning. Gas filter was done at tune-up also.
Why does my car not start when I start it?
There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start…it’s because one of these components is missing from the mix.
Why does my GM 4.3L engine not start?
No Start Condition Basics There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start, it’s because one of these components is missing from the mix.
Why does my 96 Chevy Express van not start?
Also had a similar issue spin and no start with a 96 Chevy Express Van with the 5.7L. This vehicles issue turned out to be a shorted pink wire in the wiring harness that runs up the passenger side of the block. The vehicle had died while driving several times and wouldn’t start. Then, finally after blowing a couple fuses, would start at all.
What to do if your car won’t start unless you give it gas?
Resolving car won’t start unless I give it gas problem To diagnose the fuel pump, an amp clamp is placed over the positive pump-wire. Next, start the vehicle and use a voltmeter to set and record the amperage reading. Then, compare the recorded readings to the manufacturer’s defined specification.
Can a Chevy C / K 1500 run without fuel?
Also I haven’t fully checked the Spark, but the Truck run’s fine when you spray Starting fluid into the Throttle body. Any suggestions on why the truck isn’t accepting the fuel, it cranks fine, just wont run without starting fluid. these trucks have to have between 55-65psi of fuel to run.
Also had a similar issue spin and no start with a 96 Chevy Express Van with the 5.7L. This vehicles issue turned out to be a shorted pink wire in the wiring harness that runs up the passenger side of the block. The vehicle had died while driving several times and wouldn’t start. Then, finally after blowing a couple fuses, would start at all.
Also I haven’t fully checked the Spark, but the Truck run’s fine when you spray Starting fluid into the Throttle body. Any suggestions on why the truck isn’t accepting the fuel, it cranks fine, just wont run without starting fluid. these trucks have to have between 55-65psi of fuel to run.
Resolving car won’t start unless I give it gas problem To diagnose the fuel pump, an amp clamp is placed over the positive pump-wire. Next, start the vehicle and use a voltmeter to set and record the amperage reading. Then, compare the recorded readings to the manufacturer’s defined specification.
What kind of fuel pump does a Chevy Silverado need?
It turned out the pump I put in was for a 96 C1500, which has a throttle body system and the pump only produced 20-30psi. The Fuel injection in the Silverado needs 55-65psi. Be very careful you didn’t put the wrong fuel pump in!!
