Why does Windows time service not start on my computer?
Why does Windows time service not start on my computer?
If the Startup Type of the Windows Time service is set to Automatic (Delayed Start), the Windows Time service may be started by the Time Synchronization before the Service Control Manager starts the Windows Time service task. It depends on the startup timing of the Windows operating system in question.
Why does my computer not start the first time?
Bad power supply or inadequate power supply. A bad, failing, or inadequate power supply is often the cause of this issue. If the hard drive is not getting enough power during the first time the computer starts, it cannot spin the hard drive platters fast enough to start the computer.
Why does task not start at next run time?
Often a task that runs fine from a command prompt will not work from a scheduled task because of one of many different reasons. Credentials that don’t have permissions, or no credentials at all, or no “start in” path, or relative paths being used when they shouldn’t, etc. Point is, maybe the task is starting, but is also ending immediately.
What to do when W32Time doesn’t start?
Run the sc triggerinfo w32time start/networkon stop/networkoff command to define a trigger event that suits your environment. In this example, the command determines whether an IP address is given to a host. Then it starts or stops the service.
If the Startup Type of the Windows Time service is set to Automatic (Delayed Start), the Windows Time service may be started by the Time Synchronization before the Service Control Manager starts the Windows Time service task. It depends on the startup timing of the Windows operating system in question.
Bad power supply or inadequate power supply. A bad, failing, or inadequate power supply is often the cause of this issue. If the hard drive is not getting enough power during the first time the computer starts, it cannot spin the hard drive platters fast enough to start the computer.
What to do when your time is not syncing?
1. Date & Time Settings Press Windows key+I to open Settings and go to Time & Language > Date & Time. Make sure that Set the time automatically is enabled here. If time is not syncing, scroll a little to click on the Sync button to do so manually. Check the last time it was synced as well.
Run the sc triggerinfo w32time start/networkon stop/networkoff command to define a trigger event that suits your environment. In this example, the command determines whether an IP address is given to a host. Then it starts or stops the service.
