Why does my Silverado 1500 not go into gear?
Why does my Silverado 1500 not go into gear?
Won’t go into gear. No I haven’t where is the brake switch put it in neutral and reverse. It was in the way so I used another truck to push it out of the way. The back wheel drug like something was holding it … read more I have a 2008 Chevy Silverado 1500. The issue is the truck I have a 2008 Chevy Silverado 1500.
Why does my GMC S15 Jimmy not move?
My neighbor owns a ’93 GMC S15 Jimmy 4×4. When he puts it in gear, the truck doesn’t want to move. Then he switched it to 4×4 and it still doesn’t move. I’d imagine that it could be the transmission, … read more
Why is my Trans bad on my 4L60E?
Trans seems noisy when moving in 1st and Reverse, noise goes away instantly if you shift to N or the transmission goes into 3rd gear: Reaction planetary is worn out due to high miles or insufficient lubrication. Not a critical failure, but not a good sign either.
What causes a Chevy Silverado to turn over slowly?
A weak battery will produce a weak spark at the plugs, and will turn the engine over slowly. A worn distributor cap, old or broken plug wires or a worn distributor rotor can result in a weak spark at the sparkplugs, causing the engine to turn over excessively before catching.
What kind of transmission does a Chevy Silverado have?
This is a 1993 Chevy PU 2500 single cab 4X4 with a 4L80E transmission. I have a snow plow on it and I am shifting from 1st (or drive it doesn’t matter) to reverse, after a shift or to the transmission … read more
Why is my shift lever loose on my 2009 Silverado?
I have a 2009 with a 4sp column shift. My shift lever has developed a lot of slop in it. I removed the steering wheel cover and checked the torx screw that connects the shifter to the column hoping that was the cause…it’s NOTt. The play is in the small piece that the shifter lever actually connects to.
Can a Chevy Silverado go in reverse FWD?
FWD gears work fine. will go in reverse once in awhile. removed transmission pan changed filter and chevy silverado No reverse in truck. FWD gears work fine. Vocational, Technical or Tra… Vocational, Technical or Tra…
Trans seems noisy when moving in 1st and Reverse, noise goes away instantly if you shift to N or the transmission goes into 3rd gear: Reaction planetary is worn out due to high miles or insufficient lubrication. Not a critical failure, but not a good sign either.
What should I do if my Chevy Silverado 4WD wouldn’t work?
If your 4WD system acted up (like one or both hubs wouldn’t lock or the transfer case lever refused to engage or disengage), you immediately knew what was wrong. But those days are long gone. Today, all that’s required to go four-wheeling is slowing your Silverado down below 70 mph, and then turning a switch from 2-High to 4-High.
Why does my Chevy Silverado not switch into drive mode?
Won’t switch into the drive mode you’ve selected (that is, the position indicator won’t stay lit in that selection), then again the selector switch is the suspect.
Can a truck move in drive but will reverse?
Truck wont move in drive but will reverse Any trouble lights on the dash. The only problem I had once with my 09 was not wanting to shift. I had stabilitrack warning and the traction control light was on. It drove but only in first gear. Re: need help! Truck wont move in drive but will reverse
Won’t go into gear. No I haven’t where is the brake switch put it in neutral and reverse. It was in the way so I used another truck to push it out of the way. The back wheel drug like something was holding it … read more I have a 2008 Chevy Silverado 1500. The issue is the truck I have a 2008 Chevy Silverado 1500.
What causes a Chevy truck to not move?
So transmission is working properly and shifts through gears and goes in reverse, all with Tranfer Case in 4WD Auto. With transfer case in 2WD the truck will not engage and will not move, and with 2 failures in 2WD there is clearly something wrong.
Truck wont move in drive but will reverse Any trouble lights on the dash. The only problem I had once with my 09 was not wanting to shift. I had stabilitrack warning and the traction control light was on. It drove but only in first gear. Re: need help! Truck wont move in drive but will reverse
Can a Chevy truck move in 2WD auto?
Truck will not move in 2wd, but it will in 4wd Auto. Was driving down the highway and the truck just felt like it was suddenly in neutral, reved up but not engaging wheels (transmission shifter still in “D”). It did not make any noise, or poping or clunking, it was just disengaged.
Can a truck start but won’t go into gear?
Truck starts but you put it in gear and it won’t move! Won’t go into gear. No I haven’t where is the brake switch put it in neutral and reverse. It was in the way so I used another truck to push it out of the way. The back wheel drug like something was holding it … read more I have a 2008 Chevy Silverado 1500. The issue is the truck
How to troubleshoot an automotive engine high idle?
The troubleshooting procedure for high and low idle conditions are similar, which are included in the following: Step 1 – If the check engine or service engine light soon has illuminated retrieving the diagnostic trouble codes could lead you in the right direction of what the problem is, or is related too.
Why does my Chevy Silverado not idle after a cold start?
My 89 Chevy Silverado would not idle after a cold start I took the PCV valve out and sprayed it with carburetor cleaner….no more problems!!! 5 people found this helpful. One of the MOST overlooked parts of these TBI engines is the distributor pickup coil.
Can a bad throttle position sensor cause idle surging?
Idle surging can be caused due to other issues in the car, but if it happens in conjunction with other throttle position sensor symptoms, the culprit is often the TPS. At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges. 3) Check Engine Light
Why does my GMC Sierra not shift into forward gear?
You need to get a scan done on the computer to see what code (s) is set. If it will not go into a forward gear, but will go into reverse, then you have an internal failure such as a valve stuck in the valve body, broken sprag, drum, sunshell, etc. You need to take the trans out and disassemble and look for what has failed.
What causes idle surges on a car ECM?
Idle surging can be caused due to other issues in the car, but if it happens in conjunction with other throttle position sensor symptoms, the culprit is often the TPS. At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges.
The troubleshooting procedure for high and low idle conditions are similar, which are included in the following: Step 1 – If the check engine or service engine light soon has illuminated retrieving the diagnostic trouble codes could lead you in the right direction of what the problem is, or is related too.
Why is my GMC Sierra c 1500 shifter stuck?
A friend of mine has a 1998 GMC Sierra C 1500 that had a broken shift mechanism on the column. He’s a older guy so I offered to help him out. Apparently my friend has had this issue for some time and has been just jerking the shifter hard enough to get it into gear which eventually led to the part breaking.
Why does my Chevy truck not shift out of first gear?
One possible cause of this issue could be the ignition control module or ignitor. Once they age, they are very susceptible to heat and temperature. Another possibility could be a main relay as well. Fault codes should be read…
What kind of truck won’t go into gear?
I HAVE AN 86 CHEVY C20 P-UP THAT WON’T GO INTO GEAR WHEN RUNNING (MANUAL TRANS.). I JUST CHANGED THE SLAVE CYLINDER, AND I KNOW THAT THE CLUTCH ISN’T THAT OLD. ANY IDEAS……….? … read more My neighbor owns a ’93 GMC S15 Jimmy 4×4. When he puts it in gear, the truck doesn’t want to move.
What kind of engine does a 1999 Chevy C / K have?
This 1999 Chevrolet C/K 2500 2dr HD Reg Cab 131.5 WB 4WD C6P 4×4 Truck features a 5.7L 8 CYLINDER 8cyl Gasoline engine. It is equipped with a 5 Speed Manual transmission. The vehicle is ORANGE with a Gray Vinyl interior.
I HAVE AN 86 CHEVY C20 P-UP THAT WON’T GO INTO GEAR WHEN RUNNING (MANUAL TRANS.). I JUST CHANGED THE SLAVE CYLINDER, AND I KNOW THAT THE CLUTCH ISN’T THAT OLD. ANY IDEAS……….? … read more My neighbor owns a ’93 GMC S15 Jimmy 4×4. When he puts it in gear, the truck doesn’t want to move.
What kind of gear ratio does a GMC Jimmy have?
GMC Jimmy, Suburban and Yukon and Full Size pickups 1981-1988. The NP231 was has a left side drop output and a low gear ratio of 2.72 to 1. This unit has 2WD and 4wd, combination of 2 high, 4 high, neutral and 4 low.
What kind of truck wont drive in reverse?
I have a 2003 chevy with a 4.8 auto trans. The truck drives fine in reverse but it feels like the e-brake is on. The rpms stay low and the abs light stays on and the e-brake light stays on
Why is the reverse gear not working on my 4L60E?
Valve Body Issues- A bad valve body can make the reverse gear not work in the 4L60E. If the valve body ends up warped, or if the gasket fails, it’s entirely possible that the gear won’t engage. Booster Valve- A bad booster valve can leave you without reverse in a hurry. Sun Shell- A broken sun shell will cause…
What happens when I put the car in reverse?
Put the car in reverse holding the brake the car stalls, if I go into neutral or drive it works fine. If I put the car in reverse not holding the brake it shifts rough but doesn’t stall. I have not driven the car at speeds higher than 35mph, so not sure of the other gears.