Why does my Dodge Ram have a red lightening bolt?

The red lightning bolt warning on the dash means that there is a problem with the electronic throttle control system (ECT). If you have a good quality scanner this will show up. Otherwise, have a mechanic diagnose this to find the problem.

What kind of light does a Dodge Ram have?

My 2004 Dodge Ram 15005.7 Hemi has a lightning bolt light that blinks and goes into limp mode. I replaced the throttle body and it continued to do it. I had the alternatortested at autozone and it passed with 14.87 volts. I put in another battery, still the same what else could it be.

What does the red lightening bolt on the dash mean?

The red lightning bolt warning on the dash means that there is a problem with the electronic throttle control system (ECT). If you have a good quality scanner this will show up.

How do you Idel a Dodge Ram 1500?

Where you can open the hood and pull on the throttle body string to accelerate the engine. Well this newer vehicle are equiped with an electric throttle body. So when you hit the gas pedal. They computer is not getting the signal that your are pressing on the gas pedal. In that case it’s idel-ing on its own. 30 people found this helpful.

The red lightning bolt warning on the dash means that there is a problem with the electronic throttle control system (ECT). If you have a good quality scanner this will show up.

Is it bad to have red lightning bolts in Your Truck?

Red lighting bolts in our trucks are NOT a good thing. Worse than a check engine light. Need to get the codes sorted out and understand “how serious is this” Hopefully it won’t be. Keep an eye on the forum. Others will give you good feed back.

What does a red lightning bolt on the dash mean?

The one that looks like a red lightning volt. What does this mean? My car has an automatic transmission. Hi there. The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. Get a code reader and scan the engine for any logged codes.

How to test a Dodge Caliber lightning bolt?

Slowly depress the accelerator pedal all the way to the floor. Slowly release the accelerator pedal until it is all the way back up at the rest position. Turn the ignition key to “OFF” position. Start the engine and test the throttle by see if the engine will throttle up.

When does a red lightning bolt come on the dash?

Discussion in ‘ Engine & Performance ‘ started by brandonhygema, Jun 11, 2018 . I have a 05 1500 with 5.7 and driving down the engine looses power and a red lightning bolt comes on the dash, if I shut it off and restart it’s fine sometimes for a minute and sometimes 20 minutes. It’s throwing the codes p0456 p0457 p0344 p1628.

What are the codes for a red lightning bolt?

It’s throwing the codes p0456 p0457 p0344 p1628. I know the 0344 is a cam sensor but I replaced it and the truck didn’t have a problem for about a week and now it’s back. Red lighting bolts in our trucks are NOT a good thing. Worse than a check engine light.

What are the warning lights on a ram?

The following are warning lights and indicators found in vehicles built by Ram. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are over 70 of them so be patient!

When to replace lightning bolt on Dodge Caliber?

As far as the lightning bolt, I had a throttle body issue on a Dodge Caliber, had to end up replacing it. Try cleaning the throttle body. Also check your battery. Failing batteries can cause problems with newer cars. I start watching them after 3 years, almost alway replace around 4.

How to get rid of lightning bolt on Dodge Ram?

First try to push the connector all the way in on the throttle body. It may not be making a good connection. I had to give it a good push on my 07 to get rid of the lightning bolt. I also cleaned the plug and male connectors. Try this first it only costs some time.

What does it mean when red light comes on in Dodge truck?

A couple of days ago, the truck was running fine, when all of the sudden it shuttered and the red light came on. The truck barely moved, so I pulled it over. Turned off the ignition, and it started right up. I went another mile, and it did the same thing with a loud pop (like a balloon popping).

What does a lightning bolt on the dash mean?

The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. The light may be on for a glitch and the electronic throttle control system needs to be reset. John Huffman likes this. Jun 14, 2020 at 8:10 AM #4

Why is the lightning bolt on my dash lit up?

My dash had the lightning bolt icon come on and the “check guages” light as well. Truck ran fine but I don’t know what caused this. I turned off the truck for a couple of hours and then ran it again and after 20 mins it came back on again. Ive done a lot of mods so what could be the culprit?

What’s the speed of a red lightening bolt?

This happen to me today….. A red lighting bolt was flashing on the dash. My truck would not rev and go faster. It seem as if hitting on the gas pedal did not make the truck run….. It kept itself at a minimum average speed of 35-40mph. It end up being the throttle body.

How can I fix a lightning bolt in my battery?

Went to my batteries and noticed my one battery clamp was a bit nasty and corroded but on solid. I cleaned off the wire with baking soda and water and replaced the clamp. Now my voltage is up to where it should be and no lightning bolt any more. Simple $4 fix thank goodness. Hope this helps someone down the road.

Hi there. The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. Get a code reader and scan the engine for any logged codes. The light may be on for a glitch and the electronic throttle control system needs to be reset.

Is the lightning bolt warning light a tipm?

Tried boosting, no luck, nothing. Hated to do it but got a tow to the dealer. The tow truck driver farted around with it for awhile too and had no luck. I thought for sure it was my TIPM and was hearing the Ram 1500 calling me.

When does the engine light come back on?

You need to bite the bullet, take it to a dodge dealer and have them pull codes or look at a live feed… it is called “job security” for us mechanics. The light will come back on tomorrow or three months from now if all you do is turn off your engine or disconnect the battery. Same as putting a band aid on a broken bone.

Is the Check Engine light still lit on Dodge Ram?

This article applies to the Dodge Ram 2nd, 3rd, and 4th Generation (1994-Present). It’s not uncommon for a check engine light to remain lit long after the issue setting it off in the first place has been fixed.

How to reset PCM and check engine light in Dodge Ram?

The reset procedure in your Dodge Ram is as easy as they come. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch on the front of the hood to open it. Find the power distribution center (PDC); it will be a black box near the battery. Unlatch and open the cover of the PDC.

Why did I get a lightning bolt warning light?

I thought for sure it was my TIPM and was hearing the Ram 1500 calling me. Turns out it was the wire at the positive terminal of the battery had become corroded and loose at both the battery end and the TIPM end.

What did capital Dodge dealer do about lightning bolt?

The dealer (Capital Dodge) was truly excellent, they diagnosed it right away, cleaned, tightened everything up, checked my battery and alternator and only charged me an hours labour. Away I went, everything’s fine again.

Why does my car have a lightning bolt warning light?

This procedure is typically applicable any time the battery is disconnected or replaced but may still be relevant in your case. If there are any codes in the computer that relate to the gas pedal position sensor, that could cause the lightning bolt warning light to appear as well.

How to reset the Check Engine light on a Dodge Ram?

Dodge Ram: How to Reset PCM and Check Engine Light. 1 Step 1 – Remove the PCM fuse. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch 2 Step 2 – Reset the PCM. 3 Step 3 – Re-install the PCM fuse. 4 Related Discussions.

What to do if you get lightning bolt on your dash?

1. Insert ignition key and turn to “ON” position but do not start the engine 2. Wait for all the warning lights to go out. The check engine light may remain on. 3. Slowly depress the accelerator pedal all the way to the floor. 4. Slowly release the accelerator pedal until it is all the way back up at the rest position.

When to replace lightning bolt on Dodge Ram?

When did the red light come on on my Dodge Ram?

A couple of days ago, the truck was running fine, when all of the sudden it shuttered and the red light came on. The truck barely moved, so I pulled it over.

Why does my Dodge Ram have a red lightening bolt?