Why does my dash say maintenance required?

Why does my dash say maintenance required?

The maintenance required light is notifying you that maintenance is required according to the driven distance on the vehicle’s maintenance schedule. Most often this just means your vehicle might be due for an oil change.

How do you reset the oil light on a Dodge Dakota?

Dodge Dakota Oil Change Reminder Message Reset

1. Shift the gearbox to Park Position.
2. Close all doors.
3. Push the start button to RUN Position (Ignition On) Don’t start the engine.
4. Immediately Fully depress the GAS PEDAL slowly three times within 10 seconds Make sure to depress the pedal all the way down.

How to clear the maintenance required light on Dodge truck?

Make sure that you perform the required maintenance for the truck prior to shutting off the light. When you’re ready to do this, you’ll need a special tool, called a diagnostic reset tool, which is available from Dodge (or a Dodge dealership).

How to reset the Check Engine light on a Dodge Ram?

Dodge Ram: How to Reset PCM and Check Engine Light. 1 Step 1 – Remove the PCM fuse. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch 2 Step 2 – Reset the PCM. 3 Step 3 – Re-install the PCM fuse. 4 Related Discussions.

How to reset TPMS light on Dodge cars?

How to Reset a Tire Pressure (TPMS) Light on Dodge Cars. No special tools are required to perform this procedure, however a properly formatted TPMS scan tool may expedite the relearn process Sensor 1. Inflate all tires to the pre ssure listed on the placard. 2.

Is it possible to reset the warning lights on the dash?

This will result in a warning light appearing on your vehicle’s dashboard. After the repair is complete, however, it may still be necessary to reset your the computer in order for the warning light or lights to disappear. Fortunately, this process is fairly simple. Open the hood of your vehicle.

When does the service light go out on a Dodge truck?

When it’s time to get maintenance done on your Dodge truck, a service light indicating that maintenance is required will illuminate. This maintenance light, however, will not go out until or unless you reset the system.

How do you reset the service light on a Honda Accord?

Pull down the fuse panel cover underneath the steering wheel. Plug the electrical connector on the diagnostic reset tool into the pinned connector on the round pin connector in the fuse panel. Turn the ignition key to the “II” position. Wait for the light on the reset tool to go out. When it does, the service light on your dash should also go out.

How do you reset the fuse on a Dodge Ram?

When you’re ready to do this, you’ll need a special tool, called a diagnostic reset tool, which is available from Dodge (or a Dodge dealership). Pull down the fuse panel cover underneath the steering wheel. Plug the electrical connector on the diagnostic reset tool into the pinned connector on the round pin connector in the fuse panel.