Why does my AC only work on hi?
Why does my AC only work on hi?
When a blower resistor fails, the highest fan speed usually is the only one that still works because it essentially bypasses the resistor and receives the maximum amount of voltage. When the resistor is working, it reduces the amount of voltage going to the lower fan speeds, so the fan runs slower.
Why does my AC blower motor not work?
The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all. This may also cause the blower motor to work intermittently.
Why is the resistor not working on my blower?
Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.
What kind of blower does not work on high?
1997 GMC C1500 Heater/AC Blower Will Not Work on HIGH. 1997 GMC C1500 Heater/AC blower will not work on HIGH. I have replaced the black BOSCH relay behind the glovebox, the blower RESISTOR and the blower MOTOR and still cannot get the blower to work on HIGH.
Why does my heater not work on high speed?
Heater blower motor will not work on high speed? I have replaced the black bosch relay behind the glovebox, the blower resistor and the blower motor and still cannot get the blower to work on high. I remember in older model years of gmc’s and chevys that their was a high speed blower relay that caused this issue.
Why is my blower not working in Hi ( 5 )?
The usual failure of the resistor pack is if it works in HI (5) but not in any other mode or just a few modes. When you switch to high,the blower motor relay coil circuit is grounded and voltage is now applied directly through the relay to the blower motor; bypassing the resistors. So, I would look to see if the relay is ok.
The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all. This may also cause the blower motor to work intermittently.
Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.
Heater blower motor will not work on high speed? I have replaced the black bosch relay behind the glovebox, the blower resistor and the blower motor and still cannot get the blower to work on high. I remember in older model years of gmc’s and chevys that their was a high speed blower relay that caused this issue.
