Easy tips

Why do I loose all power then come and goes?

Why do I loose all power then come and goes?

I loose all power Then comes and goes. Checked all connections and battery and everything seems tight. Make sure that you are using a fully charged, quality, known good battery and that your battery cables are clean and secure. A bad, or broken battery can cause the condition that you describe. Inspect both ends of your battery cables.

What to do if your Nissan loses power?

My nissan suddenly lost power. No check light, or missing. My nissan suddenly lost power. No check light, or missing. – Answered by a verified Nissan Mechanic We use cookies to give you the best possible experience on our website.

What causes a Harley Davidson to lose all power?

This can be caused by a loose neck or loose spokes (models w/spoke rims). Check your neck and tighten if nessacary. Also, can be caused by a bad wheel bearing. My first thought would be to load test the battery. 10v is low and if it he only gets a clicking when trying to start, that’s one sign of a bad battery.

When did my Nissan Tiida suddenly lose power?

Hi, My 2009 nissan tiida (106000 km) suddenly lost power when going up a slight hill. Steering locked up but I was able to slowly move of the road. at this stage all engine/warning lights turned on.

I loose all power Then comes and goes. Checked all connections and battery and everything seems tight. Make sure that you are using a fully charged, quality, known good battery and that your battery cables are clean and secure. A bad, or broken battery can cause the condition that you describe. Inspect both ends of your battery cables.

Why does my car not start when I jump the battery?

The problem is between your battery posts and wherever you attach your jumper cables. Bad, loose, or dirty, oxidized connection. voltage is not the end-all on whether or not a battery is dead when it’s not under load. Have someone turn the key while you are checking the battery voltage. I bet you see it drop to 3 volts.

What causes no power when pressing gas pedal?

Click to expand… Good question…..if the motor was not revving up and the car won´t move, seems the TPS at the acc pedal assembly, is faulty..but the SES light should be on. This experience was with a friend’s car of mine…

Why does my car not start when I start it?

So if you’re trying to start your car and absolutely nothing is happening, check your connections. This problem can also be indicative of solenoid problems. 2. Corrosion Corrosion is another thing that can cause a bad connection to pop up.

The problem is between your battery posts and wherever you attach your jumper cables. Bad, loose, or dirty, oxidized connection. voltage is not the end-all on whether or not a battery is dead when it’s not under load. Have someone turn the key while you are checking the battery voltage. I bet you see it drop to 3 volts.

Why does my car not start when the alternator is shut off?

In this case, the alternator is doing its job of keeping the battery going once it has been jumped, but the battery can’t hold a charge when the alternator is shut off. A dead car battery is the first sign that something might be wrong with the alternator.

What to do if your power supply is no longer working on your computer?

Test your power supply if you’re using a desktop PC. At this point in your troubleshooting, at least for you desktop folks, it’s very likely that the power supply unit in your computer is no longer working and should be replaced. You should, however, test it just to be sure.

Can a bad MAF sensor cause loss of power?

A bad MAF sensor might produce a sudden reduction in car power, but the normal failure mode is a gradual loss of power over weeks. Your engine light may come on if the sensor only has intermittent failure. If power is restored by shutting the car off and turning it back on, you are in limp mode.

Why does my water pressure go down in my house?

Loss of pressure in part of the house could be caused by the plumbing pipes. When you lose water pressure in the whole house, it could be due to the municipal water supply or the well. No water pressure at a particular faucet usually means that the faucet needs cleaning, particularly the aerator.

Author Image
Ruth Doyle