Why are the brake lights stuck on my GMC Truck?
Why are the brake lights stuck on my GMC Truck?
Replaced the “stoplight switch” on the brake pedal with a new Delco part. Previous to doing this the brake lights quit on the back, but the 3rd brake light was still on, new switch did nothing. No brake lights in back, 3rd stuck on. I have also checked all fuses in both fuse boxes and everything is good.
What causes the brake warning light to come on?
It can also be the result in worn disc brake pads. If you see the Brake Warning Light illuminated, it is probably a leak. Although, if you have a fluid level sensor in the master cylinder reservoir, you may see this light come on when the fluids are low. Brake failure is common if the fluid leaks out of the system.
What does it mean when your front brake is not working?
Brake Pull: Uneven braking means that you have one front brake on your Chevy that is not operating properly. Your brakes pull to the good side. This can be due to oil, grease or fluid on a pad, a caliper that is stuck, brake line blockage, or wheel bearings that are loose.
What to do if your brake lights are stuck?
Cleaned every connection, cleaned out the brake plug, ect. Truck is kept at about 60 degrees and is dry as can be. Still no lights. Any other ideas?
What to do when your brake lights won’t turn off?
If your brake lights won’t turn off, here’s a quick fix for your problem. Brake light sensors are an inexpensive part that may need adjusted, as you may find out when your lights won’t turn off. Loading…
Why are my abs and brake lights not working?
This is how I fixed my intermittent ABS and Brake dash lights on my Chevrolet blazer with the Kelsey-Hayes EBCM module, with out spending 1500 bucks on a new EBCM.. You may have code C0265 “Electronic Brake Control Module Motor Relay Circuit.” The fault is usually due to broken solder joints on the circuit board.
Why do I have code c0265 on my brake light?
You may have code C0265 “Electronic Brake Control Module Motor Relay Circuit.” The fault is usually due to broken solder joints on the circuit board. At this time I did not need to pull the EBCM and repair the solder. Loading…
