Where is the transfer case motor on a Dodge Ram?
Where is the transfer case motor on a Dodge Ram?
Follow the rear drive shaft to where it meets the transfer case, and to the left of the drive shaft you will see an electric motor with a wire harness connector attached to it. Use a ratchet with T45 Torx bit to remove the three (or four depending on your Ram model year) bolts securing the motor to the transfer case.
How do you change the motor on a Dodge Ram?
Use a ratchet with T45 Torx bit to remove the three (or four depending on your Ram model year) bolts securing the motor to the transfer case. Unplug the wire harness connector. Place a drain pan underneath the motor, and pull off the motor from the transfer case. A small amount of fluid will come out. Figure 2. Location of the transfer case motor.
What to do if transfer case motor fails?
If your vehicle, if your transfer case shift motor failed in 4-wheel drive and this was maybe up over here, what you would want to do is go underneath the vehicle, grab ahold of the shaft with pliers, turn it to the right position so that you can mount your new one easily.
What do I need to replace transfer case?
The items you’ll need include a new transfer case shift motor from 1AAuto.com, 10-15mm sockets with ratchet and extensions, pry bar, pliers, marker, flat blade screwdriver, crimp clamp or hose clamp, torque wrench, and you may want to use a jack and jack stands, but you can usually do this without lifting the vehicle.
How does the transfer case work on a Dodge Ram 1500?
The transfer case in the Dodge Ram 1500 has multiple gear ratios, which can be selected by moving the switch in the cabin to 2Hi, 4Hi, or 4Lo. It has been known to shift to 4Lo without warning, at any speed, and whether the vehicle is on or off. If this occurs at highway speeds, the result can be catastrophic failure of the transfer case.
What causes the transfer case to fail on a Dodge Dakota?
It has been known to shift to 4Lo without warning, at any speed, and whether the vehicle is on or off. If this occurs at highway speeds, the result can be catastrophic failure of the transfer case. This is caused by a faulty four wheel drive shift motor, selector switch (in the cab) or the wiring between the two.
Use a ratchet with T45 Torx bit to remove the three (or four depending on your Ram model year) bolts securing the motor to the transfer case. Unplug the wire harness connector. Place a drain pan underneath the motor, and pull off the motor from the transfer case. A small amount of fluid will come out. Figure 2. Location of the transfer case motor.
What should I do if my transfer case motor failed?
To correct the issue, inspect the wiring to the transfer case switch motor for damage, and replace the shift motor if needed. Disconnecting power to the shift motor will lock the transfer case in its current setting. The average cost for a Dodge Ram 1500 General Diagnosis is between $88 -$111.
