Where is the TPMS reset button on a Chevy Silverado?
Where is the TPMS reset button on a Chevy Silverado?
You’ll usually find the tire pressure monitor reset button below the steering wheel. If you can’t locate it, consult your owner’s manual before getting back on Little Rock and North Little Rock streets. Inflate your vehicle’s tires to three PSI above the recommended level, then completely deflate them.
What is the service tire monitor light on a Chevy Silverado?
This article applies to the Chevrolet Silverado 1500 (1999-2006). The service tire monitor light is a warning bulb connected with the TPMS or Tire Pressure Monitor System, which notifies the driver of low or high air pressure in the tires.
Can a tire pressure sensor be reset on a Chevy Silverado?
It allows to control tire pressure, sitting at your comfort driver’s seat. When the air goes out of the tire, your pressure sensor gives warning and all you need is just to reset it. Today we will describe how to reset tire pressure sensor if your vehicle model is Chevy Silverado, Impala, Cruze or Tahoe.
How do you reset the TPMs on a Chevy Silverado?
If your vehicle does not have the DIC buttons, press the trip odometer reset stem located on the instrument panel cluster until the RELEARN TIRE POSITIONS message displays. If your vehicle has the DIC buttons, press the set/reset button.
Why is my service tire monitor light stuck?
Common causes of a stuck light include damaged TPMS sensors and incorrect tire pressure. However, some cases may only require the tire pressure system to just be reset.
How to reset tire pressure sensor on Chevy Silverado?
If your vehicle has the DIC buttons, press the set/reset button. The horn will sound twice to indicate the TPMS receiver is ready, and the TIRE LEARNING ACTIVE message will display.
This article applies to the Chevrolet Silverado 1500 (1999-2006). The service tire monitor light is a warning bulb connected with the TPMS or Tire Pressure Monitor System, which notifies the driver of low or high air pressure in the tires.
How to turn off the service tire monitor light?
Set the truck to park. Turn the ignition to the RUN position, while the engine remains turned off. Turn the headlight switch “On” and “Off” four times in three seconds; this puts the vehicle into reset mode and will alert you with two horn chips.
How to reset service light on Chevy Silverado?
The reset procedure is tedious, and as most Chevy owners agree, unorthodox. However, this procedure must be completed in order to reset the service light. Set the truck to park. Turn the ignition to the RUN position, while the engine remains turned off.