Where is the relay for the tail lamp?

The tail lamp relay is relay number B, 2md from the left in the RH junction box 15. TAILLAMP RELAY (a) Measure the resistance according to the value (s) in the table below. If that is not the cause, I would check the headlight dimmer switch (sounds more like it because of your dash light being out as well Hope this helps, good luck.

Why are my tail lights still not working?

I Replaced the Light Bulb but the Tail Lights Still Don’t Work. Part of the series: Maintaining a Car’s Electrical System. If your tail lights won’t come on even after replacing a light bulb, this can be because of a few different things.

What to do if your license plate light is not working?

If everything works but the license plate lights, first make sure there isn’t power to the lock sockets. If there isn’t, trace the power wire back to where it connects with the other tail lights. If there is power, then replace the sockets.

How can I tell if my tail lamp is on or off?

Both tail lamps do not come on (Headlamps are normal). 1. TAIL fuse 2. TAIL relay (USA only) 3. Headlamp dimmer switch assy 4. Daytime running light relay (USA only) 5. Wire harness The tail lamp relay is relay number B, 2md from the left in the RH junction box 15. TAILLAMP RELAY (a) Measure the resistance according to the value (s) in the

How can I tell if my tail lights have a fuse?

When you have located the fuse for the tail lights use a fuse tester to check the connection. If the tester lights up – your fuse is functioning fine. If it does not light up then, replace the fuse with another of the similar amperage and size. In many instances, you can see the break in the metal strip of the fuse.

What happens when your tail lights are not working?

When the tail lights fail or do not function properly the car becomes a danger or hazard to self and others on the road. You may receive a ticket or citation from the traffic police. Blow fuse – The first thing the mechanics check is the fuse corresponding to the rear lights.

Are there any brake lights or tail lights?

I pulled over checked the fuses and again the Tail light fuse was out Put a new one in nothing. Now my taillights don’t work but Brake lights, Turn signals are good. The license plate light is out as well along with both front and rear marker lights).

Where are the relays for the dash lights?

If your dash lights work but won’t dim and your running light won’t work and your license plate lights are out. Then there are 4 relays directly above the glove box. you can’t see them until you drop the panel. There are three 10mm bolts just in front of the latch. There are 4 relays, 3 that look the same and one that is different.

Where is the relay number on a wire harness?

Wire harness The tail lamp relay is relay number B, 2md from the left in the RH junction box 15. TAILLAMP RELAY (a) Measure the resistance according to the value (s) in the table below. If that is not the cause, I would check the headlight dimmer switch (sounds more like it because of your dash light being out as well Hope this helps, good luck.

Is there no power to left rear tail light?

Re: No power to Left rear Tail light or Number plate… If the bulbs are ok check for broken cable or bad earth. both tail and number plate lights are inter connected, so if the right tail is ok you have battery voltage to there, You can’t post conmments that contain an email address.

Where are the fuses for the dashboard lights?

Check under the hood, under the dashboard, or near or in the glove compartment. Once you find the fuse box or boxes, remove the lid and check the diagram on the underside of the lid for a fuse labeled “dash lights” or just “lights.” Refer to your owner’s manual if you have trouble locating the fuse boxes or the dashboard light fuse.

How are the tail lights and dash lights connected?

Tail lights and dash lights are connected through the tail light (and/or brake light) fuse. When the dashboard goes dark you know you are driving without tail lights. Make certain to use the exact replacement dashboard light fuse to avoid the potential of electrical failure in your vehicle’s dashboard.