Where is the relay for the ABS system?

Most ABS systems typically have individual sensors mounted on or near each wheel. However, they are all controlled by a central relay that is located in the main relay panel inside your engine compartment. If you ever have to disable your ABS system, the relay is the most direct and effective way to handle it.

Where are the sensors on my ABS system?

The sensors are designed to monitor wheel speed and to regulate your brakes so that they do not lock up under certain driving conditions. Most ABS systems typically have individual sensors mounted on or near each wheel.

How do I disable the ABS system on my car?

If you ever have to disable your ABS system, the relay is the most direct and effective way to handle it. Pop your hood and remove your negative battery cable. Locate your main relay box. Locations may vary from vehicle to vehicle, but they are usually located fairly close to your battery or main fuse panel.

Are there any tricks for disconnecting sensor connectors?

Using a screwdriver to hold down the tooth is a recipe for a broken connector, if it isn’t broken already. Is there any tricks to help remove these things?

How can I reset the GM ABS brake module?

Navigate to the “ABS” menu on the computerized scan tool by pushing the down arrow button. Select “Clear all codes.” Power off the computerized scan tool and disconnect it from the DLC connector. Turn on the vehicle and verify that the ABS module is no longer lit. A computerized scan tool can be purchased online, or at any automotive supply store.

Where is the DLC connector on a GM ABS?

Locate the DLC connector found under the dashboard and just above the pedals. Plug the computerized scan tool into it and power on the scan tool. Navigate to the “ABS” menu on the computerized scan tool by pushing the down arrow button. Select “Clear all codes.” Power off the computerized scan tool and disconnect it from the DLC connector.