Where is the oil filter on a Chevy Blazer?
Where is the oil filter on a Chevy Blazer?
GM placed the oil filter directly behind the driver’s side headlight in early models of the S-10 and S-10 Blazer. If the oil filter is not under the hood, proceed to Step 2 of this article. Lift the front of the vehicle with a 2-ton or greater capacity jack. Place a jack stand underneath both lower control arms on either side of the truck.
Where is the oil filter on a 4.3 liter engine?
The second was on the lower side of the engine block, up above the steering and suspension assembly (about 2-feet up from bottom of the engine, passenger front). The final place that GM placed an oil filter on the 4.3 liter is behind a trap door in the front skid plate (Look in front of the engine for a door that says “oil filter,” driver’s front).
How to change a fuel filter on a 1990 Chevy?
How to Change a Fuel Filter on a 1990 to 2003 Chevy or GMC. – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
When do you need to replace your fuel filter?
If your car is hard to start, experiencing engine performance issues, or has the Check Engine Light on, you may need to replace the fuel filter. 1. Car is Hard to Start 2. Engine Performance Problems 3. Check Engine Light Comes On 4. Damaged Fuel Pump
How to Change a Fuel Filter on a 1990 to 2003 Chevy or GMC. – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
Why is my Chevy Vortec 4300 V6 leaking fuel?
In the L35 and LF6 engines, the spider injectors are known to leak at the pressure regulator and at the supply and return lines due to a design fault. Outside of leaking fuel onto the exterior of the engine itself, it can cause excess fuel to get sucked into the engine.
Where is the idle control valve on a Chevy Vortec?
The idle control valve sits on the throttle body and is responsible for adjusting the amount of air that enters the engine at idle, ultimately controlling engine idle speeds. At idle, the valve blocks a small amount of air from entering the engine, keeping idle RPM’s low.
Where are the intake gaskets on a Chevy Vortec?
The intake gaskets on the LB4 and L35 vortec’s are very prone to going bad which results in engine leaks, overheating, stalling, etc. The intake gasket sits between the intake manifold and the cylinder head.
