Where is the fuel reset button located?
Where is the fuel reset button located?
Look for the fuel pump switch or inertia switch. This is a small box with a plastic button on top and an electrical connector at the bottom. On some vehicle models, this will be located in the luggage compartment. Look on a side panel for a small, round button which you can pry off with a small screwdriver.
How do you reset a inertia switch?
Press down the rubber reset button on the top of the inertia switch. 3. Turn the ignition switch to position ‘II’, pause for a few seconds, then return the key to position ‘0’.
Is there a way to reset the Ford fuel shut off?
To reset your Ford’s inertia switch, press down on the reset button. Although the location of the shut-off switch varies by year and model, Ford has stuck with a few common spots over the years.
How do you reset a gas shut off valve?
Slowly turn the “reset” shaft on the valve 1/8turn in the direction indicated. Remove the screwdriver from the slot, the slot in the shaft will automatically rotate back to its original position. Look in the sight glass window. If you see green the valve is reset and in the open position.
What causes a Ford fuel pump to shut off?
If your Ford ever fails to start or stalls on you suddenly, the first thing to check is the inertia fuel shut-off switch. The switch is designed to trip and cut power to the fuel pump in the event of a collision, but you can also trigger it by hitting a large bump or pothole as well.
Where is the fuel cut off switch on a Ford Fiesta?
Steps to Locate and Reset Fuel Cut Off Switch on Ford Fiesta (For Other Cars Keep Reading) First, open the glove compartment. Pull out the glove compartment by firmly pressing the left side toward an inner section. Look for a device with a rubber yellow cap on it. Push the rubber yellow cap on inertia switch.
To reset your Ford’s inertia switch, press down on the reset button. Although the location of the shut-off switch varies by year and model, Ford has stuck with a few common spots over the years.
If your Ford ever fails to start or stalls on you suddenly, the first thing to check is the inertia fuel shut-off switch. The switch is designed to trip and cut power to the fuel pump in the event of a collision, but you can also trigger it by hitting a large bump or pothole as well.
Where is the fuel pump shut off switch located?
On Ford, Peugeot, VW, Citroen, Vauxhall, Subaru, Renault, Toyota and Mazda, inertia switch location is usually on one of the following two hidden places: Behind or below glove compartment, sometimes hidden under the carpet; On the driver side, between the footrest area and door, sometimes hidden under the carpet.
When do you reset the fuel cut off switch?
After speeding over a deep pothole, speed bumper, or after a car accident, you could end up with an engine unable to start. In most cases, you only need to reset the fuel cut off switch, which was activated by the impact. It looks simple, right?
