Where is the fuel pump located on a 2009 Chevy Traverse?
Where is the fuel pump located on a 2009 Chevy Traverse?
the 2009 and up Lambdas (traverse, acadia, enclave, outlook) have 2 fuel pump. 1st pump in the tank. this sends gas towards the engine… the 2nd pump is the high pressure fuel pump.It is attached to the side of the engine— it is in the area below the throttle body..
Does Chevy Traverse have a fuel filter?
The fuel filter needs to be changed every 30,000 miles. The 2009 Chevrolet Traverse has fuel filter, but it is designed not to be replaced. Chevrolet implements a fuel filter inside the fuel pump, and it is meant to last for the life of the vehicle.
Where is the fuse box on a 2009 Chevy Traverse?
Fuse box location It is located underneath the instrument panel, on the passenger side, under the cover.
What’s the difference between a P30 and P37 chassis?
The “P30” term is simply too generic to help when specifics are needed. If the 5ththru 7 positions in your VIN number are “P37”, then you have the motorhome version of the chassis. Actually, it is the ‘7’ that tells us we have the motorhome version of the chassis. (See Appendix C for the VIN breakdown.)
Is the G10 chassis the same as the P30 chassis?
The same chassis series has been used for G10, G20, G30, P20, P30, and Motorhomes under a ’32 – 52′ designation. What’s more, the alignment specs are different for the motorhome chassis because they were made slightly different.
When did the Chevrolet P chassis service guide come out?
A majority of the information is taken from the 1995 and 1997 “Chevrolet Motor Home Chassis Service Guide” for the P Chassis. However, the information has been presented in what is felt to be a logical sequence to accomplish that most elusive item for this chassis – good handling. Age is the common enemy of the chassis.
What should torque cap be on P chassis?
If it exceeds .003 inches in either assembly, adjust to within 0 to .003 inches. Set large lock nut torque cap to 25 ft. lbs. and then loosen 1/16 turn and tighten lock nut. If there is side play, replace the bushings.
Where is the Chevy P30 fuel pump relay?
Well the book shows 3 places it could be. 1 where I already said, 2 under the doghouse on drivers side, 3 inside of the frame rail in the rear. The relay should have 4 but could have 5 or 6 wires in it. The orange wire is 12v power, black= ground, dk/grn/wht is switched power, gray goes to the pump.
Where is the oil pressure sender on a Chevy P30?
To find it, I first had to find the oil pressure sender, which is at the FRONT of the engine…the front lower driver’s side corner of the engine block, directly under the power steering pump and AC pulleys if you dropped a plumb straight down. Looks to be in decent…although original…shape, and isn’t leaking oil.
The “P30” term is simply too generic to help when specifics are needed. If the 5ththru 7 positions in your VIN number are “P37”, then you have the motorhome version of the chassis. Actually, it is the ‘7’ that tells us we have the motorhome version of the chassis. (See Appendix C for the VIN breakdown.)
The same chassis series has been used for G10, G20, G30, P20, P30, and Motorhomes under a ’32 – 52′ designation. What’s more, the alignment specs are different for the motorhome chassis because they were made slightly different.
