Where is the fluid in the bobcat 753?

All of the sudden a warning buzzer went off and hydraulic fluid was dumping from the underside of the machine. Refilled with fluid, cab up, started machine, no visible leaks but fluid is rapidly collecting on right hand side. Literally lost 3 gallons of new fluid in seconds. Any one have any ideas?

Where does the hydraulic fluid go in a bobcat?

How much does it cost to rebuild a bobcat 753?

They have a cap on the ends, didn’t find the leak until i took the cap off. Bobcat charged about $100 to rebuild it out of the machine and said 4 to5 hours of labor on top of that if they took it out. With the cap off it will spray straight toward the back of the machine. Willie the 863 is gone/sold, now the 753 is left.

Where is the gushing fluid on the bobcat?

Welcome to HeavyEquipmentForums.com!! ALL NEW MEMBERS PLEASE READ THIS FIRST!!! Bobcat 753 “gushing” hydraulic fluid beneath seat on right hand side of machine. Discussion in ‘ Skid Steers ‘ started by CarpenterRick, Sep 8, 2011 . Machine was running great, has approx 1800 hrs.

How to fix hydraulic fluid leak in Bobcat 753?

Raise loader arms and install safety prop on right side. Jack the machine up and support wheels off ground with sufficient stands or blocks. Raise the cab, make certain the cab lock properly locks cab. Start engine, let it remain at idle. Inspect compartment with good light looking for leak, but avoid allowing any stream of oil to spray your skin.

How much oil is in a bobcat 753 chain case?

Discussion in ‘ Skid Steers ‘ started by KyDirt, Jan 17, 2015 . Bobcat 753 C Series Machine. Close friend passed away recently and left me his 1994 753 bobcat. Going through the machine to do routine service. Removed the chain case CHECK PLUG and 12 gallons of excess oil puked out before it drained down to the proper fill level.

Where is the pump outlet on a bobcat 753?

The pressure outlet fitting of work pump is on the backside (engine side) of pump, be sure and check that area for failed o-ring on pump outlet fitting. Still don’t see leak, lower cab enough to drop seat bar and activate drive/equipment enable button, raise cab back up.

Is the bobcat 753 locked up in the garage?

753 locked up,traction lock,it is in garage and cant get the cab raised,no overhead room,please help with pressure relief valve knowledge,i need to move out of garage to work on,,any help would be grateful!!!!!!!!

Where is the Traction Lock on a bobcat S250?

Not sure about a 753, but on my S250 there is a fuse and relay box that is inside the cab just below and in front of the seat. It contains a 30 amp fuse and a relay for the traction lock. If you can find a similar box on yours, I would start there.

Why is my Traction Lock not working on my 753?

5 bucks says it’s the solenoid, I had that problem twice on my 753, usually from heat from the alternator pumping out a little too much power or heat from the hydraulics. Not sure about a 753, but on my S250 there is a fuse and relay box that is inside the cab just below and in front of the seat.

Why is Bobcat 753 left steer control not working?

Re: Bobcat 753 – left steer control is not working at… Testimonial: “Thanks Bill ,have removed and checked the two check valves that are on top of pump and no sign of wear or damage .Would the next option be to pull motor out to get to the two release valves underneath .?” You can’t post conmments that contain an email address.

Can you print out a manual for a bobcat?

This manual works after installing Adobe PDF Reader, which allows you to find the necessary information to the user, as well as to print out individual pages or the entire text as a whole. This service manual is for the Bobcat loader mechanic. Note: this product covers 2 PDF files for Bobcat Skid Steer Loader 753 model. DIVERTER VALVE (OPT.)

Where is the fluid in the bobcat 753?