Where is the Factory Brake Controller on a Silverado Sierra?
Where is the Factory Brake Controller on a Silverado Sierra?
To the left of the steering wheel, there is a Light knob and a 2WD/4WD knob, and a square cut out above them for loose change or whatever. The cut out is where the factory trailer brake controller would go, if installed from the factory.
How to fix brake problem in silveradosierra trailer?
The short answer is to… Make sure your 12v feed is connected under hood. The trailer needs this (or a battery) to run the hydraulic pump. Get a couple of brake magnets and wire them together in parallel. At the pump in the trailer,find the blue wire (0-10V electric brake wire) and splice it in one side of the magnets.
Why do I need a trailer brake controller?
If people can add all the other factory options to a non equiped truck why would the trailer brake be any different?
How to install a brake controller on Chevrolet / GMC 1999?
Hardwire the open wires of the brake control adapter to the wires on the brake controller. Plug the other end of the adapter into the electrical junction box (see above). Mount the brake controller in a place that is easily accessible. A: Remove the bracket in the corner closest to the driver. B: Remove the top cover of the “Accessory Fuse Block”.
How to wire a trailer brake control to a Chevy Silverado?
Hard-wire the connections from the brake controller to the blue, black and white dead tails left under the dash if a “plug-and-play” harness is not installed; they are normally left loose but bundled with tape somewhere below and behind the dials.
What’s the name of the wire for the brake controller?
The first wire (black) runs to the vehicle’s battery to supply power to the trailer connector. This wire is called the “12 volt hot lead.” The second wire (blue) runs to the brake controller to supply power to the trailer brakes. This wire is called the “brake wire.”
Where is the brake controller on a GM Truck?
Y ou have to grind down the front of the original switch front to allow it to clip in place with the new (PC Case) front cover. Mounted the control head on the new cover (you have to center and drill hose). Mounted the controller on the front case of the brake controller plug in box. Plugged everything together and went on down the road.
What do Butt connectors do for a brake controller?
Butt connectors help to make connections between wires. Ring terminals attach to the end of wires and hook around battery posts and circuit breakers. Zip ties help to bind loose wires together and prevent them from interfering with vehicle components such as brake and gas pedals. Find a suitable location to mount the 7-way connector.
