Where is the ECM located on a 2002 Dodge Durango?
Where is the ECM located on a 2002 Dodge Durango?
The powertrain control module (PCM) in your Dodge Durango is located on the right (passenger side) of the engine compartment.
How do you reset the PCM on a Dodge Durango?
Another way to reset the PCM is to scan and clear any diagnostic trouble codes that have triggered the MIL light. You will need a scan tool or code reader/eraser to perform this; they’re not always readily available for everyone.
Where is the powertrain control module located on a Dodge Durango?
How do you change the battery in a Durango?
Open the hood of the Durango. Locate the battery and remove the black-wired negative terminal from the battery. Turn the ignition key to the “on/crank” position for 30 seconds, then replace the ignition key to the “off” position. Reconnect the negative battery terminal and close the hood.
Where is the PCM located on a Dodge Durango?
by Jody L. Campbell. The powertrain control module (PCM) in your Dodge Durango is located on the right (passenger side) of the engine compartment. It is the circuit board computer for the SUV designed to withstand extreme temperatures.
What are the most common problems with a Dodge Durango?
Even so, it’s important to understand a vehicle’s pitfalls before you commit — so here are the most common Dodge Durango problems as reported by RepairPal. The most commonly reported issue with the Durango is its exhaust manifold bolts breaking. This tends to impact vehicles at an average mileage of 112,030.
How much does it cost to repair a Dodge Durango?
RepairPal estimates the repair costs at $642-$845. Dodge Durango drivers also occasionally report water passing through the windshield’s cowl screen during heavy rainstorms or when going through a car wash, generally causing the Check Engine light to illuminate.
The powertrain control module (PCM) in your Dodge Durango is located on the right (passenger side) of the engine compartment.
