Where is the drain plug on a 2008 Chevy Silverado?
Where is the drain plug on a 2008 Chevy Silverado?
GM Tech Mike Looking up with engine facing the front then you will see it on the passenger side of the oil pan, you’ll need a 13mm wrench. Be carefull as the oil will hit the corner of your drain pan and splatter all over the passenger tire and even on you if you are on the ground.
When to change the oil on a 2008 Chevy Silverado?
The 2008 Chevy Silverado uses an “Engine Oil Life System” to notify you when to change the oil. This system determines when an oil change is needed based on engine temperature and revolutions, a more sophisticated approach than counting mileage.
What kind of oil does a Chevy Silverado use?
If your Silverado 1500 is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Silverado 1500. Most Chevrolets have the oil type printed on the oil cap – it will likely be 5W-20, 5W-30, 5W-40, 10W-30 or 10W-40.
How to reset the oil life light on a Silverado?
To reset the Oil Life Light on 2007 2008 2009 2010 2011 2013 Chevrolet Silverado, conform to the following instructions: Turn the ignition on without starting the engine. Press the accelerator pedal to the floor three times within five seconds. If the “Change Oil Soon” light flashes, the system is resetting.
How to reset the change oil message on a Chevrolet?
Press and hold the “Reset” button on your information center (check mark symbol) until the “Oil Life” display changes to 100 percent. Turn your ignition to position “A” (Lock/Off). 2002 to 2006 Chevrolet Silverado. Insert your key into the ignition, and turn it to position “A” (Run/On) without cranking the engine.
The 2008 Chevy Silverado uses an “Engine Oil Life System” to notify you when to change the oil. This system determines when an oil change is needed based on engine temperature and revolutions, a more sophisticated approach than counting mileage.
If your Silverado 1500 is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Silverado 1500. Most Chevrolets have the oil type printed on the oil cap – it will likely be 5W-20, 5W-30, 5W-40, 10W-30 or 10W-40.
What kind of wrench do I need to change the oil in a Chevy Silverado?
The original engine oil drain plug wrench size should be a metric size. Most use a 15mm and on some models, a 13mm. Use a typical banded oil filter wrench for the filter. The recommended oil viscosity is 5W-30 or 10W-30.
Where is the oil filter on a Chevy Silverado?
Locate the oil filter and oil drain plug underneath the truck. The oil drain plug is near the bottom of the engine block, and on the Silverado, the filter is to the left of the drain plug. Remove the oil drain plug using the socket wrench.
