Where is the crankshaft sensor on a Chrysler Town and Country?

I have a 2007 Chrysler town and country I’m having the crankshaft position sensor replaced but the mechanics at Fletcher’s can’t find where the part is!! They say it’s supposed to be in the back but it’s not some forms say it’s up from does anyone have any idea.

What to do if your crankshaft sensor is stuck?

A small 10mm bolt holds it in place, spray some lube around it before you try to remove it, and work it out slowly as they sometimes get stuck. I have a 2007 Chrysler town and country I’m having the crankshaft position sensor replaced but the mechanics at Fletcher’s can’t find where the part is!!

Where is the crankshaft sensor located on a car?

The 3.3/3.8L crankshaft sensor is located on the rear of the transmission housing, above the differential housing The bottom of the sensor is positioned next to the drive plate. Remove the 10mm bolt holding the sensor in place and remove the sensor. Install the new crankshaft sensor.

Where can I find the crankshaft position sensor?

Find the crankshaft position sensor. On some models, you will be able to find the sensor hidden somewhere around the starter motor. Other engine models might have the sensor closer to the transmission. Remember that only the top of the sensor’s body, where the electrical connector plugs into, will be visible.

What does the crank sensor on a Chrysler do?

The crankshaft position sensor on your Chrysler vehicle is part of the ignition system and monitors engine speed. The engine computer uses electrical current signals from this and other sensors to change ignition timing for better engine performance.

Where is the crank shaft position sensor located?

This sensor is located on the transmission bell housing just behind the engine and underneath the cross over exhaust pipe. A faulty crank shaft position sensor can cause a not start or stall. It can also cause random misfires.