Where does the car thermostat go?
Where does the car thermostat go?
In most cars the thermostat is placed under a housing near the water pump on the cylinder head ; the housing is connected directly to the top radiator hose . In a few cars the thermostat is housed near the bottom hose. Test the thermostat quickly by starting the engine from cold.
Can a thermostat be installed in the wrong direction?
Answer: A thermostat installed backward will cause the engine to overheat quickly, similar to a thermostat being “stuck closed.” Therefore, always double check that the thermostat is installed in the correct direction, and if equipped with a jiggle valve you install it according to the Factory Service Manual.
Where is the thermostat located on an engine?
The thermostat provides control for your engine’s warm-up period. The thermostat is located between the engine and the radiator. This little temperature-sensitive spring valve stays closed during engine warm-up.
Can a thermostat be installed upside down on a car?
On some cars, it is impossible to install the thermostat upside down simply because it will not fit back in the housing. However, on other cars or trucks, it is entirely possible to install the thermostat backward and has been done by countless people.
When does the temperature thermostat start to open?
The temperature at which the thermostat is designed to open is called its rating, and may be stamped on the body. The 180 Degrees F thermostat begins to open at (you guessed it!) 180 Degrees F and is fully opened at 200 degrees F. Different engines use different temperature thermostats.
Answer: A thermostat installed backward will cause the engine to overheat quickly, similar to a thermostat being “stuck closed.” Therefore, always double check that the thermostat is installed in the correct direction, and if equipped with a jiggle valve you install it according to the Factory Service Manual.
Which is the correct way to install a thermostat?
Therefore, always double check that the thermostat is installed in the correct direction, and if equipped with a jiggle valve you install it according to the Factory Service Manual. Which way does the jiggle valve go?
Why does the thermostat have to be near the engine?
Think of it this way: The thermostat tries to keep the engine temperature constant. So the sensing part of the thermostat has to be toward the engine. Coolant over the thermostat will cause it to close immediately. The temperature spring. Also, your thermostat may have a small hole with a “jiggle pin” the air out of the system.
What causes a Ford thermostat to close immediately?
Coolant over the thermostat will cause it to close immediately. The temperature spring. Also, your thermostat may have a small hole with a “jiggle pin” the air out of the system. Replace tt with t (twice!) and remove parentheses to email me directly.
