Where can I find the NP241DHD transfer case?

Here is the Parts Blow-out for the NP241DHD You can find any of the part numbers for the transfer case using the part number lookup tool. The link below will take you to the transfer case section for a 2nd gen Dodge Ram Truck. Ensure you get a good quality Rebuild kit. I used BK241C, you can find that on ebay for ~$125

Is the Dodge np-241 process transfer case heavy duty?

Loading zoom… DODGE NP-241 NEW PROCESS TRANSFER CASE, HEAVY DUTY The following parts are always replaced: bearings, seals, fork pads, viscous (when the unit has them) and chains. Buy in monthly payments with Affirm on orders over $50.

Is there a 241 DLD to 241 DHD swap?

241 DLD to 241 DHD swap. We have a tie for May. Help break the tie with 24 hours of voting HERE! Hi, i am currently swapping my old DLD to a DHD. and I found out the input shaft is different, well my problem is i am not sure the easiest way to change the two. can anyone help? Thanks btw i have to have the truck by satrday at this time.

Where to find part numbers for LD transfer case?

The R&R for the LD transfer case should be very similar. Here is the Parts Blow-out for the NP241DHD You can find any of the part numbers for the transfer case using the part number lookup tool. The link below will take you to the transfer case section for a 2nd gen Dodge Ram Truck.

What’s the difference between np-241 and NP241 transfer case?

This is a NP-241 Transfer case for a drivers side front drive shaft, with 27 teeth on the Female input spline. This case will mate up with a TH350 or the 700R4 / 4L60-E Automatic Transmissions…WITH THE PROPER ADAPTER-Not Included. It came out of a 1989 Half Ton K1500 pick-up, and was yard tested. Our Tag # 002467

What’s the difference between a Dodge 241 and a C?

Dodge 241’s are not C’s. An NP246 is worth a lot more than a boring 241 d-drop 27 spline case. Don’t go getting hosed in the name of a little quickness. Click to expand… This is a NP-241 Transfer case for a drivers side front drive shaft, with 27 teeth on the Female input spline.

What is the input bearing number on the NP241?

When researching the NP241 you will see a lot of chatter about wide input bearing verses narrow bearing, here is what you need to know: the wide bearing is .940 and is part number BD50-8, the narrow bearing is .630 and part number is 6010N. It is a good idea to check your input bearing number prior to ordering any parts.

Where can I find the NP241DHD transfer case?