Where are the Upfitter switches located on a Ford?
Where are the Upfitter switches located on a Ford?
Description: The Ford Upfitter Switches are optional overhead console mount switches (Option Code 66S) that control under hood mounted relays. These relays power six blunt cut wires that are taped on a harness near the upfitter auxiliary relay box that can be found on the driver’s side of the engine compartment.
Where is the blunt cut on the upfitter switch?
Figure 2: Upfitter Relay Box and upfitter switch blunt cut output location. On vehicles with dual batteries, removing the upfitter relay box will provide additional access to the blunt cut wires. 1. Disconnect the electrical connector. 2. Release tabs and lift upwards to remove.
How to install upfitter relay box fuse F4 ( 5A )?
1. Disconnect the electrical connector. 2. Release tabs and lift upwards to remove. 1. To install, reverse the removal procedure. Configuring Upfitter Switches 5 and 6 to Hot-at-all times. Upfitter relay box fuse F4 (5A) can be put into one of two positions. In Position A, auxiliary switch 5 and 6, operate with the ignition in RUN or START.
What does the upfitter interface module ( UIM ) do?
The UPFITTER INTERFACE MODULE (UIM) is an electronic control module that has the ability to operate equipment (such as lift buckets, cranes, motors, salt spreaders, snow plows, etc) with external automotive grade relays via customer programmable logic based on switch inputs and CAN signals. The operation of such equipment
Where are the two 40A Upfitter switches located?
The wires are also tagged from the factory to show amperage and which Aux switch that wire operates. What to do to get power to the two 40a switches at all times.
Can a upfitter switch be used in Run mode?
The Upfitter Switches cannot be utilized in any other operational mode. The power to the switches is relay controlled and was designed to operate in the “run” mode to reduce the possibility of draining the battery (ies).
Figure 2: Upfitter Relay Box and upfitter switch blunt cut output location. On vehicles with dual batteries, removing the upfitter relay box will provide additional access to the blunt cut wires. 1. Disconnect the electrical connector. 2. Release tabs and lift upwards to remove.
Where are the Upfitter switches located on a Ford Super Duty?
In addition to the upfitter switch blunt cut wires, this bundle contains the following blunt cut circuits: All relays and fuses are located in the upfitter relay box. NOTE: Upfitter Switches cannot be added to a vehicle that was not built with this option at production.
