Where are the rivets on a fuel door?
Where are the rivets on a fuel door?
Open the door and notice on the left side of the round housing there are either two screws or two rivets side (one above and one below the door hinge). Remove the screws if you have them. Otherwise, use the 17/64” drill bit to drill out the rivets. You need to be careful and go slowly to ensure that you do not damage the paint will drilling.
Which is the best fuel filler door housing?
Fuel Filler Door Housing by OxGord®. 1 Piece. Replace that broken fuel filler housing. Highly durable and manufactured to match OE form, fit, and function. Rigorously tested to ensure the best quality standard.
Where do you put the spring on a fuel door?
Remove the three screws holding the plunger housing to the back of the face plate. Then, remove the P1 plunger and the spring. Apply Vaseline or similar lubricant to the P2 plunger. Insert the spring in the rear hole of the plunger and place them inside the plunger housing with the plunger notch point up (see pictures above).
How do you attach a fuel door hinge?
Use the (2) 10-24 x ¾” Phillips head screws to attach the hinge to your vehicle. The next step is to ensure the door plate is level and is centered inside the opening. Use the two screws just installed and the fours screws that attached the hinge to the fuel door face plate to center and rotate the face as needed.
Open the door and notice on the left side of the round housing there are either two screws or two rivets side (one above and one below the door hinge). Remove the screws if you have them. Otherwise, use the 17/64” drill bit to drill out the rivets. You need to be careful and go slowly to ensure that you do not damage the paint will drilling.
How do you install a new fuel door?
Here is what you need to do: Open the fuel door and push the hinge away from the door with your finger. Find and remove the two screws on the top of the bottom of the fuel door. Set the old door aside and grab the new one. Start the screws in the new door prior to taking to the vehicle.
How does the fuel door open and close?
The fuel tank door moves on a hinge, which is mounted to the body, usually found on one side or the other of your trunk. When you open the fuel door, a spring helps keep it open. Some swanky automobiles use a cable to pop the fuel door open when you pull a lever inside the vehicle. This works just like the hood release cable.
Fuel Filler Door Housing by OxGord®. 1 Piece. Replace that broken fuel filler housing. Highly durable and manufactured to match OE form, fit, and function. Rigorously tested to ensure the best quality standard.
