Easy tips

When does a 1992 S-10 Blazer start to stall?

When does a 1992 S-10 Blazer start to stall?

Sometimes it starts right back up and … read more 1992 S-10 Blazer starts and runs well until driven a few minutes. Begins to run rough, then stalls and may die completely. Re-start after a few minutes and runs well until driven a short distance, the … read more I have a 2001 Chevy Silverado.

How long does it take to reset engine control module?

After a few minutes all the old data should be reset so plug the fuses back in and turn your vehicle back on. You will want to leave your vehicle at idle for at least 10 minutes which will give your ECM enough time to “learn” any new modifications installed on your vehicle.

Why did my 2000 Chevy Silverado stop running?

My 2000 Chevy Silverado Pickup stopped running. It will start My 2000 Chevy Silverado Pickup stopped running. It will start and run for a few seconds, but then stalls. I’ve changed the fuel filter, rotor and rotor cap with no success.

What causes a car to start and stall?

Check to make sure your spark plug wires or ignition coils are seated properly on each of the spark plugs. A detached or malfunctioning spark plug wire will cause misfires and often a stall as the engine struggles to stay running on fewer cylinders.

How can I tell if my car is stalling?

Would need to have a fuel pressure gauge on the engine and watch to see if it drops as it stalls, and if it it is low when trying to restart- and it won’t. Pressure needs to be at least 55 PSI. You can also try tapping on the ignition switch to see if you can cause it to stall.

What causes a car to start at the wrong time?

Spark plug wires are a source of electromagnetic interference (EMF), but this is usually only a problem on some aftermarket setups when this interference isn’t taken into account. A timing belt or chain that has skipped a tooth will throw off the cam timing, causing the intake and/or exhaust valves to open at the wrong time.

How does a Chevy Blazer start and stall?

One end is a snap or quick disconnect that you squeeze the 2 tabs and it pulls off (after pressure released). The other end requires 2 open end wrenches. The bracket it is in is held on by one 13mm bolt to the frame that has to be taken off to get the filter out of the bracket and the lines are simply snapped in to the top of that bracket.

Why does my 1996 Blazer not start up?

Installed aftermarket stereo in my 1996 blazer. Now the speedometer tach dosent work and tranny dosent shift out of first VBulletinNew fuel pump started but then died won’t start back up 2000 4 door 4wheel drive Gear box Crankcase Oil leak Buzzing Jerking/Hesitation Stalls

What kind of problems does a Chevy Blazer have?

I have a 1974 Blazer with a 305 in it, I just replaced spark plugs, cap, rotor, wires, fuel filter, some hoses and PCV valve. It starts up strong, runs fine for a bit – drive it around the neighborhood – then once I come to a stop it basically dies on me, sometimes it will start right back up again – sometimes it will just crank and crank.

Why does my 2005 Chevy Trailblazer die at idle?

Clean it thoroughly and then take it on a test drive. Once the idle is re-learned, your problem will be solved. Also the radio control **** to turn channels or volume and on and off won’t work the radio and cd will switch back and forth,, what could could cause this — 2005 trailblazer.

Author Image
Ruth Doyle