When did Dodge stop making the Ram Van?
When did Dodge stop making the Ram Van?
DaimlerChrysler discontinued production of the Ram van and Ram wagon after the 2003 model year, replacing them with the M-B-based Dodge Sprinter . For the first eight model years, the different configurations of B vans were given names.
What are the warning lights on a ram?
The following are warning lights and indicators found in vehicles built by Ram. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are over 70 of them so be patient!
When did Dodge Ram get a new grille?
In 1986 the Ram van was given a new grille to resemble those of the 1986 Ram trucks. In 1994 the entire front end was redesigned with flush headlamps to resemble the all-new Dodge Ram pickups]
What kind of engine does a Dodge Ram have?
Big-block V8 engines were the 400 in 3 (6,600 cm 3) and 440 in 3 (7,200 cm 3) (1976–1978). Certain model years came with an optional 5.2-liter engine utilizing compressed natural gas (CNG), with a range of up to 300 miles (480 km) on a full tank, and CNG-powered Ram vans were classified as super ultra-low emission vehicles in 1999.
What happens when the ignition switch on a Dodge Ram goes bad?
Your Ram stalls because the faulty switch turns off the fuel pump or power to the ignition. When this happens, the engine will not be able to run until it gets that signal back. 2. Starts then Dies If your Dodge Ram is starting right up, but then immediately dies, that is a very good indication that the ignition switch is bad.
The following are warning lights and indicators found in vehicles built by Ram. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are over 70 of them so be patient!
How to reset the Check Engine light on a Dodge Ram?
Dodge Ram: How to Reset PCM and Check Engine Light. 1 Step 1 – Remove the PCM fuse. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch 2 Step 2 – Reset the PCM. 3 Step 3 – Re-install the PCM fuse. 4 Related Discussions.
Where is the reset button on a Dodge Ram?
The reset procedure in your Dodge Ram is as easy as they come. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch on the front of the hood to open it. Find the power distribution center (PDC); it will be a black box near the battery.
DaimlerChrysler discontinued production of the Ram van and Ram wagon after the 2003 model year, replacing them with the M-B-based Dodge Sprinter. Original B series[edit]
How big is a Dodge Ram conversion van?
Dodge Ram Conversion Vans — built by factory-approved conversion specialists — are the only line of full-size vans available in three lengths (187.2 in., 205.2 in. and 231.2 in. Maxi) and three load ranges (1500, 2500 and 3500 lbs.). This wide choice allows customers to tailor their van to specific needs and requirements.
Which is the last full size Dodge van?
For 2003, DaimlerChryslerintroduced the Dodge Sprinter(produced by Mercedes-Benz), making the B-platform van the last full-size van designed by Chrysler; Ram Truckscurrently markets the Ram ProMaster(a rebadged Fiat Ducato).
What are the features of a Dodge van?
The vans came with a single sun visor, two-speed wipers, single driver’s seat, turn signals, heat, painted hubcaps, backup lights, and some other items considered essential today.
Is the wheelbase of a Dodge van fixed?
All American vans are now produced with wheelbases proportional to the body length (i.e. made longer to match van size), rather than a fixed length that does not change with body or roof size extensions (as with the E-series and Ram vans).
What kind of truck is a Ram Van?
The Sportsman, Tradesman, and Adventurer names were phased out after 1980, replaced with the Ram van moniker, which included the Ram wagon for passenger models. As with the D-series trucks, B100 and B150 models were 1/2-ton rated, B250 models were 3/4-ton, and B350s were one-ton.
