Easy tips

When did check engine light stop on C1500 Chevy?

When did check engine light stop on C1500 Chevy?

That style of diagnostic procedure stopped in 1996, when the Environmental Protection Agency (EPA) standardized On-Board Diagnostics. Checking an engine made after 1996 requires a handheld scanner. If your Chevrolet C1500 has the ability to self test, then it was manufactured before General Motors began to phase in OBD-II coding.

What causes a flashing check engine light on a Chevy Silverado?

While a majority of the time, the flashing check engine light is going to be caused by a misfire related to your Silverado’s ignition system or fuel system (as stated above), there are other issues that can cause it. Your timing chain could have jumped .

What is the diagnostic code for a Chevy check engine light?

Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Chevy diagnostic trouble codes. Manufacturer Specific Codes P0342Camshaft Position Sensor A Bank 1 Low Input – Related Information P1031HO2S Heater Current Monitor Control Circuit Sensors 1

How to clear service engine soon light 1990 to 2002 Chevy?

If playback doesn’t begin shortly, try restarting your device. As an Amazon Associate I earn from qualifying purchases. I am a participant in the Amazon Associates Program, an affiliate advertising program designed to provide a means to earn fees by linking to Amazon and affiliated sites.

How to self test the Check Engine light for a c1500 Chevy?

Place the C1500 into self testing mode. To do this, insert the C1500’s key into the ignition and switch to the “On” position. Leave the C1500’s engine off and uncranked. Count how many times the C1500’s check engine light flashes and observe how long the flashes last. Each flash code is different.

Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Chevy diagnostic trouble codes. Manufacturer Specific Codes P0342Camshaft Position Sensor A Bank 1 Low Input – Related Information P1031HO2S Heater Current Monitor Control Circuit Sensors 1

What to do if your Chevy engine light is blinking?

The easiest course of action is to bring your car over to the Service Department at Larry H Miller Chevrolet for one of our certified technicians to investigate the diagnostic code and isolate the cause.

What makes the Check Engine light go away?

Oftentimes if the gas cap wasn’t tightened enough, the check engine light will display. If tightening the gas cap does not make the light go away, take the vehicle in to have the diagnostic codes looked up. If you follow those three simple rules and keep up on your vehicle’s maintenance, your vehicle will last you a long time.

Can a 1999 Chevy c1500 / k1500 start?

Hi, our 1999 CHEVROLET C1500/K1500 is having the same issue. After sittiing for a few hours, we have to crank it and eventually put a little gas or tarting fluid in the throttle body for our truck to start but runs and drives fine once it does start and will start right up after only sitting for about an hour or so. 205 people found this helpful.

Where to find Flash codes on a c1500 Chevy?

You can find them on the Internet; the C1500’s manual does not have them. If you own a Haynes Repair Manual for your model year, you can find descriptions for Chevy’s flash codes in the engine-related chapters. Place the manual or your print outs in the C1500’s navigator seat.

Why does my C / K 1500 have no power?

I have a ’97 k1500 with a 350 and 4l60e automatic. Assuming all things are OK with the truck, would a bad fuel pressure regulator cause it to have no power at low rpm’s?

That style of diagnostic procedure stopped in 1996, when the Environmental Protection Agency (EPA) standardized On-Board Diagnostics. Checking an engine made after 1996 requires a handheld scanner. If your Chevrolet C1500 has the ability to self test, then it was manufactured before General Motors began to phase in OBD-II coding.

Why are my brake lights not working on my 1997 Chevy?

Pull the plastic cap off the fuse chassis and you’ll see a square relay fuse switch and replace it for the brakes. It’s only $13 bucks and is the predominant issue with 1997 Chevy Trucks and the brakes not working especially if you reverse and blinker lights do work. Was this answer helpful? Its the taillight circuit board or a broken wire.

You can find them on the Internet; the C1500’s manual does not have them. If you own a Haynes Repair Manual for your model year, you can find descriptions for Chevy’s flash codes in the engine-related chapters. Place the manual or your print outs in the C1500’s navigator seat.

Where are the brake lights on a C / K 1500?

There is a switch. I think on most C/K 1500/2500 it is on the brake pedal arm or the arm hits it. It is $5-$10; you might take ALL your truck data to the auto parts store, buy a new switch, then look for the same thing around the brake arm or under the hood. There’s a fuse. Find the fusebox and look for “brake”. The Owner’s Manual may have clues.

Author Image
Ruth Doyle