What was the ABS code on my 2002 Ford F-150?
What was the ABS code on my 2002 Ford F-150?
Abs system malfunctioned code reported by service tech was c-10-95 and stated that I would need to replace the hydraulic control unit. Failure occurred at only 17,500 mile on the unit. See all problems of the 2002 Ford F-150 .
Why is my abs light not working on my Ford F-150?
Abs light commences to illuminate while driving 25 mph or more. Vehicle was taken to a repair shop, and mechanic determined that the abs control module needed to be replaced due to corrosion. The dealer and the manufacturer were not notified. See all problems of the 2000 Ford F-150 .
What are the problems with a 2002 Ford F-150?
Failure occurred at only 17,500 mile on the unit. See all problems of the 2002 Ford F-150 . 1. Loss of brake fluid, tough to brake, brake light went on 2. Abs module corroded 3. Abs module replaced at my expense ($1400. 00).
Are there any brake problems in my Ford F-150?
Ford F-150 owners have reported 14 problems related to brake antilock control unit/module (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford F-150 based on all problems reported for the F-150.
When do ABS kick in when coming to a stop?
When coming to a stop, the ABS will kick in when under 10ish mph. I started to happen after I changed my driver front wheel bearing. It was a cheap Ebay bearing, so, now, about 3-4 months later, I bought a new wheel bearing and installed it today to see if it changed. Nope.
Why does my ABS pump run non stop?
The ABS pump is not having the typical issue where it runs non-stop, but it kicks in for no reason. Swhitney is right. The problem is called “unintended low speed ABS activation”. There was a recall for trucks in the “rust belt”.
Why does my abs go bad under 5 mph?
A dealer has AT LEAST a tech2 scanner which has graphing capabilities. Its easy, you graph the data of all 4 wheels (3 with a solid axle), stop the car and the wheel the loses signal is the culprit. Usually under 5 mph the bad will read 0 mph indicating a lock wheel to activate abs.
Is there a problem with my Silverado ABS?
Sorry…
