What tools do I need to change my starter?
What tools do I need to change my starter?
Tools needed to replace a starter:
- Sockets and wrenches.
- Screwdriver.
- Pliers.
- Battery terminal puller.
- Drive-on ramps, jack or jackstands.
How do you replace a starter on a Dodge Ram?
Mount the 8mm and 13mm nuts back to the starter. Then tighten down the wire leads. Line the starter bolts up with the transmission. Slide the two 16mm starter bolts back in place. Start with the top bolt and hand tighten it. Then slide in the lower bolt. Torque down the upper and lower starter mounting bolts.
How to remove a car starter from the engine?
Remove the starter retaining bolts then the starter. 1 Be sure to use the correct size socket, otherwise you risk damaging the bolts. 2 You may need to pull on the starter with a bit of force in order to remove it from the engine once the bolts have been… More …
How do you start a Dodge Ram truck?
Start with the top bolt and hand tighten it. Then slide in the lower bolt. Torque down the upper and lower starter mounting bolts. Once the starter is installed, remove the jack stands, slowly lower the truck, and reconnect the battery. Figure 3. The starter installed.
Do you need to disconnect the positive cable on a car starter?
You will not need to remove the positive cable on the battery. Always disconnect the battery before servicing the electrical system in your vehicle. Jack up the vehicle if need be. In some applications, you may need to jack up the vehicle in order to access the starter.
Mount the 8mm and 13mm nuts back to the starter. Then tighten down the wire leads. Line the starter bolts up with the transmission. Slide the two 16mm starter bolts back in place. Start with the top bolt and hand tighten it. Then slide in the lower bolt. Torque down the upper and lower starter mounting bolts.
Remove the starter retaining bolts then the starter. 1 Be sure to use the correct size socket, otherwise you risk damaging the bolts. 2 You may need to pull on the starter with a bit of force in order to remove it from the engine once the bolts have been… More
Start with the top bolt and hand tighten it. Then slide in the lower bolt. Torque down the upper and lower starter mounting bolts. Once the starter is installed, remove the jack stands, slowly lower the truck, and reconnect the battery. Figure 3. The starter installed.
You will not need to remove the positive cable on the battery. Always disconnect the battery before servicing the electrical system in your vehicle. Jack up the vehicle if need be. In some applications, you may need to jack up the vehicle in order to access the starter.
