What to do if your Dodge Ram lights are not working?

Double check to ensure the correct bulbs were being used in your headlights in the first place. Double check any wires to the connectors and the fuse box which may be frayed or damaged. Visit dealership to purchase the new fuse box. Remove TIPM from truck and swap in the new fuse box.

Why does my Dodge Caravan Say No fuse?

Same thing. 2012 Dodge Gran Caravan no fuse on the display when I tried to turnthe engine on. No error code at AUTO ZONE. Took your luck and ran with it. A NEW battery did the trick! I had working radio and everything so it was confusing. The battery was fully charged by me and wouldn’t start still.

Why does my Head Light not turn on?

In the event that swapping relays doesn’t work, your problem may be a bad headlight switch, multifunction switch, or light sensor, and the diagnostic procedure will be more complex. You may be able to identify the problem by simply removing the component in question and checking for physical damage, but there won’t always be physical indicators.

Where is the fuse box on a Dodge Ram?

The fuse panel is located behind the cover on the driver’s side of the instrument panel. The fuse box is near the battery.

What happens when a fuse is blown on a Dodge?

Identify the fuse connected to your problem circuit and pull it from the fuse box. A blown fuse doesn’t always leave burn marks on or around the fuse. There are a pair of connections inside the fuse that you should be able to see through the clear plastic. If these connections are broken, then the fuse is blown and needs to be replaced.

How do you change fuse on Dodge Ram?

Connect the positive probe of the multimeter to the fuse and the negative probe to the nearest ground wire. Check both ends of the fuse and compare the voltage. If there’s a major difference in the voltage between the two ends, then the fuse is blown and needs to be replaced.

What are the fuses for the dash lights?

Pretty sure if you check your fuse box there are some fuses one black a couple yellows the black fuses for a temporary parking so that there’s no drain on your battery underneath that black cover is the fuse that controls your dash lights in the clock check that one and that should probably clear it up

Where are the fuses on a ram truck?

Fuse box diagram (fuse layout), location and assignment of fuses and relays Ram Trucks 1500, 2500, 3500 (2013, 2014, 2015, 2016, 2017, 2018). Before replacing a fuse check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.

What does light out indicator mean on Dodge Ram?

Some manufacturers, like Dodge, in addition to the “light out” indicator, have a “chime” that alerts the driver that a light is out. Keep reading for a step-by-step guide for diagnosing various lighting problems in your Ram. It is possible that you may get a light out indicator on your instrument panel but can’t actually find the bulb which is out.

How do you put fog lights on a Dodge Ram?

Click to expand… This. The headlight switch is also your fog lights. You press the large knob you use to turn on the headlights for the fogs. The little button off to the side turns on your cargo lights. I’d be willing to bet that’s what you might be doing as well.

Where is the fuse on a Dodge Ram?

Unlatch and open the cover of the PDC. Take a look at the diagram on the back of the cover. Identify the fuse for the PCM. Depending on your Ram truck model, it will either be fuse #19, #23, or #31. Pull the fuse from the PDC. Figure 1. The inside of the cover should look something like this.

Why are the headlights not working on my Dodge Ram 2500?

The contact owns a 2004 Dodge Ram 2500. While operating the vehicle, both the high beam and low beam headlights would not illuminate. Also, the rear driver’s side window would not operate due to damaged electrical wires located in the driver side door panel.

Why are the low beams on my Dodge Ram not working?

I started researching other causes for the issue and discovered that 2006 and later model year Dodge trucks have no fuses nor relays controlling power to the lights. When you turn on the headlights, the wires to the low beams return a signal to the ECM (Engine Control Module) which sends power to the lamps. Really?

Can a Dodge Ram 3500 start no communication?

Dodge RAM 3500 Quad Cab: truck wont start no communication… truck wont start no communication… truck wont start no communication with ecn and finaldrive control module will not crank over and I have no p r n d display on dash

Why does my Dodge Ram 1500 not have power?

All power comes on, but won’t even crank when turn the key. Check fuses, bench tested starter, replaced the FCM (Front Control Module) bc for some damn reason Dodge has multiple computers under the hood. Somebody HELP!

Why is my low beam headlight not working on my Dodge Ram?

After replacing the driver’s side headlight bulb twice on our 2006 Dodge Ram 2500 SLT 4WD Cummins Diesel pickup, the low beam still wasn’t working. I swapped the known good bulb from the other side and the low beam was still out, even though the high beam and fog lights were all functional.

How to diagnose lighting problems in a Dodge Ram?

Keep reading for a step-by-step guide for diagnosing various lighting problems in your Ram. It is possible that you may get a light out indicator on your instrument panel but can’t actually find the bulb which is out. Look again. Inspect all bulbs including brake lamps, turn signals, fog lights, license plate lights, etc.

How do you change the headlight bulb on a Dodge Ram?

Pry off the electrical harness clip and pull the bulb from the socket. Insert the new bulb to the socket. Reinsert the bulb socket to the headlight housing and twist the ring clockwise to lock it in. Figure 1. headlight bulb socket. Be sure not to touch the headlight bulb or you’ll get dirt and grease on it.

What kind of headlights does a Dodge Ram use?

Early 2nd gen Rams used a pull switch to control the headlights that was unfortunately prone to shorting out on itself. Later rams switched to a more modern rotary switch. Both switches are prone to problems with the connectors, but replacing them is not too difficult. Tilt your steering wheel down.

If you’re positive that all the lights are functioning properly when the turn signals or hazard lights are selected (be sure to check with and without the headlights on), then you may need to “reboot” your truck. Disconnect the battery for at least 30 minutes (you will have to reset your radio/clock)]

What did the check gauge light come on on my Dodge Ram?

My 2004 5.7 Hemi Today the check gage light came on and the oil PSI fell down to zero when I turned a cornner. It was one quart low so I added one quart of oil and it seems fine now. Just sharing.

When does the Check Engine light come on?

My 03 Dodge Ram check engine light came on and check gages while driving about 30 mph. Truck powered down for a second then lights went off and truck powered back up without me doing anything. Any ideas? 18 people found this helpful.

What’s the problem with my Dodge Ram 1500?

2008 dodge ram 1500 4.7 check gauge came on went i turn on i shut off and turned back on and light are gone any idea whats wrong with it… 16 people found this helpful. No Guru, but im having the same problem on my 08 Ram.

What are the symptoms of a Dodge Ram overheating?

If any part of this system fails, your Ram will eventually overheat. Dodge Ram Overheating Symptoms. Here are the most common symptoms of a vehicle overheating. 1. Gauge/Temp Light. Your Ram will be equipped with a temperature warning light and/or a temperature gauge. The most common symptom of overheating is the temperature light coming on.

What should I do if my engine temperature warning light comes on?

Under no circumstances should you keep driving after the engine temperature warning light comes on. Overheating will quickly ruin your engine and put a big dent in your pocketbook. Turn your heater on full blast, pull off the road as soon as you safely can, and shut off your engine once you’re off the roadway.

What’s the temp on a Dodge Ram when idle?

When I rev the engine, the temperature gauge moves slowly back to the 200° range, but when left to idle, it moves back up to 250°. It doesn’t move past that point, I was concerned that it would eventually move to the red line and overheat. After idling more than 30 minutes, it did not. I’ve had the water pump replaced about 8 months ago.

What’s the red light on the engine temperature gauge?

A temperature gauge that has a red light at the hot end of the temperature range. A red or yellow light that will come on and even blink when the engine temperature is too high.

How does a park lamp relay work on a Dodge Ram?

The FCM turns on the park lamp relay by grounding a circuit through the circuit board. The normal repair done on these is to replace the IPM, but as you’ve found it’s quite expensive. What I’ve been doing for a few years now is opening them up, finding and repairing the bad spot on the circuit board with solder.

Why is my a / C unit not working in my Dodge Ram?

The condenser fan motor may have died. The condenser fan is designed to keep the heat away from the A/C system. When the fan stops working, Freon will heat up and be unable to cool down quickly, causing the vents to blow hot air at times. To check the condenser fan, open the hood and observe if the fan turns off when the engine is running.

How to troubleshoot no running lights but turn?

Then you want to inspect the running light wires throughout the trailer. They’re traditionally brown wires but may not be. Since you have two they’ll be the second and third wires starting on the side with the ground pin. Take a look at the picture I attached. Check for any damage or pinch points.

Why are the lights on my Dodge Ram not working?

Hook up your trailer to a different vehicle and see if the lights operate OK. If they don’t, then the issue is with the trailer, not the truck. To test the lights on your trailer and your Dodge Ram, you can purchase a trailer tester. Click here to check out trailer testers.

Where are the tail lights on a Dodge Ram?

Pick up the input feeds from the Dodge Ram tail lights in the wiring harness then splice the output signals into the trailer’s tow connector. Click here to check out information about Modulite 119190 units.

Why are the lights on my boat trailer not working?

Malfunctioning lights on your boat trailer, hauler, or camper might indicate grounding problems or something more complex. Read on for a fix to your particular issue. This article applies to the Dodge Ram (2002-2008). Have the lights on your Ram’s trailer been malfunctioning?

What happens when a running light switch fails?

The headlight/running light switch is used as the trigger circuit which sends a signal to activate the relay. When this relay fails, it will hinder the operation of the running lights. Learn More