What to do after Idle Relearn on Chevy?

Blue Streak Electronics recommends to warm the engine after the idle relearn procedure, without use of the air conditioner. After the engine is warm, switch the air conditioning on and off, and then put the transmission into the “drive” position. These actions complete the full idle relearn procedure.

What should the idle speed be on a GMC V8?

A V8 should idle at 500rpm. GoNDown, did you recently disconnect your battery? After I left mine dead in the yard for a while and didn’t charge it, when I started it up it ran like you describe for a few days and then it was fine. I think it was doing a crank relearn (I no longer remember why I came up with that theory, though).

What should the idle rate be on a 1997 GMC Truck?

Underdog, I don’t know the 1997 5.7, but 1000rpm sounds like a high idle, not where it should “bottom out”. A V8 should idle at 500rpm. GoNDown, did you recently disconnect your battery? After I left mine dead in the yard for a while and didn’t charge it, when I started it up it ran like you describe for a few days and then it was fine.

What’s the idle RPM on my Chevy Suburban?

My 1997 Chevy Suburban (5.7) is acting up on me. When I start it up the RPM and idle seem fine. As I let it sit for a couple of seconds the RPM’s slowly begin to drop until they finally bottom out at about 1K. As soon as I put it into Reverse/Drive etc. the RPM’s drop below that mark and it struggles to stay running.

When do you need an idle relearn procedure?

An idle relearn procedure must be performed if a computer, or chip, is replaced in the vehicle. An idle relearn procedure is a way to reprogram the vehicle’s computer memory to idle at a specified RPM, or revolutions per minute.

How does a GM throttle body relearn procedure?

A motor and gear reduction set inside the throttle body opens and closes the throttle plate to accomplish your request. Over time, carbon buildup can accumulate around the throttle plate, changing it’s “home” position. If the buildup occurs gradually, the PCM “learns” the new home position.

Why is my GM 4.8l engine running too lean?

The engine may be running too lean, due to a leaking intake manifold. Too lean means too much air and not enough fuel; according to the power control module (PCM) calculation. When the engine is cold, not all sensors function. As the engine warms up the oxygen sensors report the lean condition.

Is there an engine misfire code on a GM 4.8L?

Engine Misfire or Rough Engine Idle on GM 4.8L, 5.3L, 6.0L is becoming; more common and getting harder to diagnose. Because, GM V8 engines are very prone to a rough idle and engine misfire when cold. The check engine light may also come on, with codes P0300, P0171 and PO174.

What causes rough engine idle or TDC code?

So, should the engine misfire, rough engine idle or (TDC) code; point to an air leak in the intake manifold gasket, following the below directions. A very common cause of a leaking intake manifold is the gaskets and bolts used from the factory.