What should the steering be like on a Chevy Silverado?
What should the steering be like on a Chevy Silverado?
Steering should be like a bowl of pudding: smooth and noiseless. Continue reading to make sure the steering in your Chevy Silverado stays like a bowl of pudding. This article applies to the Chevrolet Silverado GMT800 (1999-2006).
How to replace clunking on a Chevy Silverado?
Use your 15mm box wrench to hold the bolt head still as you remove the 15mm nut using the ratchet and socket. Once the nut is off, push the bolt out of the hole and separate the two shafts. You might have to get crafty with some kinetic persuasion, also known as whacking things with a hammer, but make sure not to get your fingers. Figure 3.
What to do if your Chevy Silverado steering wheel spins?
Intermediate steering shaft connections and bolts. Once the bolt and bracket are out, the steering wheel will be able to spin freely, but don’t let it. Make sure to keep it still in top dead center position or you could risk damaging some of the electronic components inside.
How to replace the steering column on a Chevy Silverado?
Insert the bolt back into the new steering column shaft. If you’re having trouble getting the bolt all the way through the bracket on the top end of the steering shaft, flip the ignition (but don’t start the car), then gently move the steering left and right to wiggle the bolt through. If playback doesn’t begin shortly, try restarting your device.
How to fix the ” steering clunk “-Silverado Sierra?
Okay, so after several positive reviews and a suggestion to make this a how-to, here’s my roughly 3 minute video on how to fix the steering clunk often found in 03-06 GM trucks. As far as I know, this should work in all GM trucks and SUV’s from 2003-2006, but I bet it will work on newer as well as older rigs.
Why does my steering clunk when I Turn Left?
Borg-Warner actually makes a specific steering-shaft that was specifically made to replace the stock/factory units that are responsible for the clunking noise when turning the steering wheel to the left or right while making turns. I had a local shop, that I trust with my vehicle do mine.
Why does my Chevy Silverado make a clunking noise?
But in GM’s infinite wisdom, they overlooked the matter of the so-called “intermediate shaft” in the steering assembly, and that oversight has led to an unfortunate clunking noise. The intermediate steering shaft has also led to a number of technical bulletins, but that’s another story.
Steering should be like a bowl of pudding: smooth and noiseless. Continue reading to make sure the steering in your Chevy Silverado stays like a bowl of pudding. This article applies to the Chevrolet Silverado GMT800 (1999-2006).
