What should the charger voltage be on a Camaro?
What should the charger voltage be on a Camaro?
From the above (KOEO = key on engine off and KOER = key on engine running). By 12V above I mean battery voltage, which may be 12V when engine is off but could be up to 14.5V when engine is running. Check the light: Ground the brown #4 terminal wire at the regulator. When grounded the light should come on.
How long does it take to charge a Camaro battery?
One has to let the alternator charge the battery back up after starting, 2500 RPM for 5 minutes, therefore the reason requesting temperature, the higher the temps, the less charging voltage needed to recharge.
What does Terminal 3 on Camaro Charger do?
Terminal #3 is battery power so this puts battery power on both sides of the bulb and turns it off. This means the brown #4 wire should go to +12V. Also, this connects the field terminal right to battery power but still going through the points.
Where does the power lead go on a Camaro Alt?
The power lead from the alt goes to the fender harness and is crimped to the wire going from the horn relay to firewall connector, then to the horn relay buss bar, then onto the other attached red wire to the buss bar, then across rad support to a junction block, then to battery cable clamp.
What is the electrical system on a Camaro?
Second Generation Camaro Owners Group – Camaro Wiring and Electrical Information The electrical system is critical to your cars operation. It might seem like a complex and confusing mess, but if you approach this logically and use the sites wiring diagrams you’ll be able to understand what’s going on.
One has to let the alternator charge the battery back up after starting, 2500 RPM for 5 minutes, therefore the reason requesting temperature, the higher the temps, the less charging voltage needed to recharge.
From the above (KOEO = key on engine off and KOER = key on engine running). By 12V above I mean battery voltage, which may be 12V when engine is off but could be up to 14.5V when engine is running. Check the light: Ground the brown #4 terminal wire at the regulator. When grounded the light should come on.
When to disconnect negative terminal on Camaro Z28?
WARNING: ALWAYS ALWAYS DISCONNECT THE NEGATIVE TERMINAL BEFORE PLAYING WITH THE WIRING SYSTEM. Failure to do so will require you to quickly learn where the fusable link is located and how to replace it. Also some circuits aren’t fused. If you screw up, you will have a fire. Here’s the wiring in my 1974 Z28.
