What should I do about my Dodge Caravan radiator?
What should I do about my Dodge Caravan radiator?
Turn off the Dodge Caravan and check the coolant level. If the level retreated, put more coolant into the radiator until it is full again. Put the radiator cap back on and close the hood. Move the Dodge Ram to a level surface to make flushing the radiator easier. Be sure to set the parking brake before beginning any work on the truck.
How long does it take to change the coolant in a Dodge Caravan?
Allow the engine to run for at least 10 minutes after you introduce the cleaning agent. Repeat the drain and refill procedure two more times to rid the system of cleaning solution and dissolved minerals, which will manifest as a milky haze in your previously clear coolant.
How do I flush the radiator in my Dodge Intrepid?
Open the hood of the Dodge Intrepid and touch the radiator to verify its temperature. If it’s hot or even warm, allow it to cool down before you attempt to open the radiator. Turn the radiator cap one turn and step back. Wait a few seconds and then finish removing the radiator cap.
How much coolant do you need for a Dodge Ram?
Allow the Dodge Ram to run until the cooling fan turns on two separate times. Turn off the engine and recheck the radiator level. If fluid level went down, add more coolant to the radiator. In all, you will need approximately 5 gallons of coolant for the Dodge Ram radiator.
How do you flush a Dodge Ram radiator?
Figure 2. Loosen the radiator drain valve and drain the coolant. After you dispose the old coolant, close the drain plug and fill the radiator with distilled water. Once again, open the drain valve and let the water drain out of the radiator. Repeat this process at least three times. Be sure to watch the water draining out of the radiator.
Turn off the Dodge Caravan and check the coolant level. If the level retreated, put more coolant into the radiator until it is full again. Put the radiator cap back on and close the hood. Move the Dodge Ram to a level surface to make flushing the radiator easier. Be sure to set the parking brake before beginning any work on the truck.
How do you change the coolant in a Dodge Ram?
Use the recommended coolant (make sure to get the correct color) and fill the radiator as well as reservoir tank. Replace the radiator cap. Replace the drain plugs. Use Teflon tape on the threads for the engine block. Replace the battery cable.
How do you drain coolant from a radiator?
Place a tray underneath the drain plug. Then, using your wrench, loosen the drain valve. Let it drain until it’s empty. Figure 2. Loosen the radiator drain valve and drain the coolant. After you dispose the old coolant, close the drain plug and fill the radiator with distilled water.
