What kind of engine is a Dodge Durango made of?

What kind of engine is a Dodge Durango made of?

4.7L ENGINE 9 – 7 DESCRIPTION AND OPERATION (Continued) OIL PAN mance. The exhaust manifolds are made of high silicon molybdenum cast iron. A perforated core graphite exhaust manifold gasket is used to improve DESCRIPTION sealing to the cylinder head.

What are the main bearings on a Dodge Durango?

CRANKSHAFT MAIN BEARING SELECTION (1) Service main bearings are available in three grades. 4.7L ENGINE 9 – 29 REMOVAL AND INSTALLATION (Continued) (4) Remove the four bolts and washers retaining the mount to the transmission (4×4 automatic trans- mission only) (Fig. 38).

What kind of chain drive does a Dodge Durango have?

There are no shaft speed DESCRIPTION changes in the secondary chain drive system. Each The valve springs are made from high strength secondary chain drives a thirty tooth cam sprocket chrome silicon steel. 4.7L ENGINE 9 – 7 DESCRIPTION AND OPERATION (Continued) OIL PAN mance.

What to look for in a Dodge Durango service manual?

1. Refer to Group 8D, Ignition System. 2. Worn or burned distributor rotor. 2. Replace distributor rotor. 3. Worn distributor shaft. 3. 9 – 10 4.7L ENGINE DIAGNOSIS AND TESTING (Continued) SERVICE DIAGNOSIS—MECHANICAL CONDITION POSSIBLE CAUSES CORRECTIONS NOISY VALVES 1. High or low oil level in 1. Refer to Group 0, Lubrication and crankcase.

What are torque specifications for Chrysler 5.9L 360ci V8?

Bell Housing To Engine Block 67.79 Connecting Rod To Crankshaft 61.01 Crankshaft To Engine Block 115.24 Cylinder Head To Engine Block 122.02 Flexplate/Driveplate To Crankshaft Intake Manifold To Cylinder Head Oil Pan To Engine Block Oil Pump To Engine Block 47.45 Oil Pump Cover To Oil Pump 10.74 Pulley To Vibration Damper/Hub 16.67

How much torque does a 360ci engine have?

122.02 Flexplate/Driveplate To Crankshaft Intake Manifold To Cylinder Head Oil Pan To Engine Block Oil Pump To Engine Block 47.45 Oil Pump Cover To Oil Pump 10.74 Pulley To Vibration Damper/Hub 16.67 22.6 Rocker Arm Shaft To Cylinder Head 40.67 Thrust Plate To Engine Block 17.5 23.73 Timing Chain/Belt Cover To Engine Block 40.67

What are the torque specifications for an engine?

Torque specifications are for stock factory type bolts with light engine oil applied to the threads and the underside of the bolt head. Other lubrications offer reduced friction and increased bolt tension, and will affect the torque figure.

What are the torque specs for a Dodge Dakota?

NOTE: The following torque specs apply to: 2000, 2001, 2002, and 2003 4.7L Dodge Dakota and Durango. IMPORTANT: The cylinder head bolts are ‘ torque to yield ’ bolts and should be replaced when the cylinder head gasket is replaced. 32 ozs. 6.1 ozs. 7.1 ozs. (System Total) 30 ozs. 28 ozs. 8 ozs. 10.1 ozs. 7.1 ozs.