What is the OBD code for a Dodge Ram 1500?

Hello, I have a 2004 Dodge Ram 1500 / 5.7 Hemi with a OBD-ll Code of : P0406 EGR Sensor “A” circuit “High” . I pulled the EGR valve and it was clean , but I can’t find this “Sensor A” .

What does the p0406 Dodge engine code mean?

Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P0406 DODGE code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

Where is the EGR sensor on a 2004 Dodge Ram 1500?

Hello, I have a 2004 Dodge Ram 1500 / 5.7 Hemi with a OBD-ll Code of : P0406 EGR Sensor “A” circuit “High” . I pulled the EGR valve and it was clean , but I can’t find this “Sensor A” . Nor can I find out any information about it . Does Anyone know where it is located? The only schematics I have ac…

What should the p0406 EGR sensor reading be?

There is a feedback sensor on most EGR valves that informs the computer of the actual EGR position. This sensor usually ranges between .4 and 5 volts If this EGR position sensor has an abnormally high reading for too long, this code may set. Symptoms of a P0406 DTC may include:

I bought a 2006 dodge ram 1500 with the 5.9 l hemi. I replaced one of the catalytic converters due to it being hollow and after I started the truck and the codes p0038 and p0058 and it stutters when racing up the engine…. I am getting the OBD codes p0032, p0038, p0052, and p0058.

What does OBD II fault code p0038 mean?

What Does Code P0038 Mean? OBD II fault code P0038 is defined as “Oxygen Sensor Heater Control Circuit High (Bank 1 Sensor 2), and is set when the PCM (Powertrain Control Module) detects a signal voltage from oxygen sensor #2 that does not fall within the predefined range for that sensor.

What are the symptoms of a p0038 DTC?

If the PCM detects an abnormally high voltage condition on the heater circuit, P0038 may set. This code is only referring to the heating circuitry half of the Oxygen sensor. Symptoms of a P0038 DTC may include: MIL (Malfunction indicator lamp) illumination There would likely be no other symptoms.

Is the p0038 sensor on a 2007 Jeep Wrangler?

2007 Jeep Wrangler, I had an issue with a code that popped up and it was p0038. I have replaced the sensor to a brand new OEM sensor from jeep. I checked all wires and connections before installing the brand new sensor, nothing frayed or broken.

Hello, I have a 2004 Dodge Ram 1500 / 5.7 Hemi with a OBD-ll Code of : P0406 EGR Sensor “A” circuit “High” . I pulled the EGR valve and it was clean , but I can’t find this “Sensor A” .

What are the trouble codes on a Dodge?

1 Dodge Codes 2 Trouble Code 3 P0171 4 P0300 5 P0301 6 P0340 7 P0420 8 P1000 – P1099 (Fuel and air metering and auxiliary emission control) 9 P1200 – P1299 (Fuel and air metering – injector circuit) 10 P1300 – P1399 (Ignition system or misfire)

What is the oxygen sensor code for a Dodge check engine?

P1196O2 Sensor 2/1 (Bank 2, Sensor 1) Slow During Catalyst Monitor – Read Our Article on Oxygen Sensor CodesFor Help With This Dodge Check Engine Light Code P1197O2 Sensor 1/2 (Bank 1, Sensor 2) Slow During Catalyst Monitor – Read Our Article on Oxygen Sensor CodesFor Help With This Dodge Check Engine Light Code

What is the diagnostic code for a Dodge check engine light?

Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Dodge diagnostic trouble codes. Manufacturer Specific Codes P0138HO2S12 High Voltage – Related Information

What is the OBD code for a Dodge Ram 1500?