What is the fault code 64 for Eaton Cummins?
What is the fault code 64 for Eaton Cummins?
373© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved2019.08.28 Fault Code 64: Gen2 Electronic Clutch Actuator (ECA) |Fault Isolation Procedures TRTS0940 Fault Code 64: Gen2 Electronic Clutch Actuator (ECA) J1587: MID 130 PID 34 FMI 2, 7, 12 J1939: SA 3 SPN 788 FMI 2, 7, 12 Overview
How to troubleshoot Gen2 ECA fault code 64?
TRTS0940 Fault Isolation Procedures | Fault Code 64 Troubleshooting Gen2 ECA Fault Code 64 Troubleshooting Gen2 ECA 1. Record the transmission fault codes, FMIs, occur – rences, and timestamps from the Service Activity Report created during the Diagnostic Procedure. 2. Key on with engine off. 3. Connect ServiceRanger. 4.
What should the temperature be on the EATC self test?
The EATC module self-test will detect concerns in the system control functions and will display hard diagnostic trouble codes (DTCs) in addition to intermittent diagnostic trouble codes for concerns that occur during system operation. The vehicle interior temperature should be between 4°-32°C (40-90°F) when carrying out the self-test.
How to troubleshoot Gen2 transmission fault code 64?
All rights reserved376 TRTS0940 Fault Isolation Procedures | Fault Code 64 Troubleshooting Gen2 ECA Fault Code 64 Troubleshooting Gen2 ECA 1. Record the transmission fault codes, FMIs, occur – rences, and timestamps from the Service Activity Report created during the Diagnostic Procedure. 2. Key on with engine off. 3. Connect ServiceRanger.
How much does it cost to diagnose a p1264 code?
The cost to diagnose the P1264 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The EATC module self-test will detect concerns in the system control functions and will display hard diagnostic trouble codes (DTCs) in addition to intermittent diagnostic trouble codes for concerns that occur during system operation. The vehicle interior temperature should be between 4°-32°C (40-90°F) when carrying out the self-test.
What happens if there are no DTCs on the EATC self test?
If a condition exists but no DTCs appear during the self-test, refer to the Symptom Chart Condition: The EATC System Is Inoperative, Intermittent or Improper Operation. To exit self-test and retain all intermittent DTCs, push the blue (cooler) button.
Can a NGS test be used for EATC?
A NGS tester must be used to retrieve these concerns. The EATC module self-test will detect concerns in the system control functions and will display hard diagnostic trouble codes (DTCs) in addition to intermittent diagnostic trouble codes for concerns that occur during system operation.
