What happens when you plug in the fuel pump control module?
What happens when you plug in the fuel pump control module?
It dropped to zero from 1.5, so the control module was apparently doing something. So I thought hell, what happens if I plug it back in to the fuel pump. So I plugged the harness back into the fuel pump and spun the starter, fuel spraying out strong. So it evidently fixed itself?
How to check for a faulty fuel pump?
THIS WILL POWER THE PUMP TO RUN AND CHECK FOR A FAULTY FUEL PUMP. 3. NEXT, CHECK FOR FUEL PUMP SIGNAL AT THE FUEL SYSTEM CONTROL MODULE. 4. FIND THE DARK GREEN/WHITE WIRE IN PIN13. WITH A TEST LIGHT CONNECTED TO THAT WIRE, TURN THE KEY TO THE RUN POSITION.
How to diagnose a faulty fuel system control module?
AT THE BOTTOM OF THIS PAGE, YOU WILL FIND THE YOUTUBE VIDEO FOR THIS PROCEDURE. YOU WILL ALSO FIND THE PIN OUT DIAGRAM FOR THE FUEL SYSTEM CONTROL MODULE FOUND ON 2007 AND NEWER GM VEHICLES. PLEASE REFERENCE THE DIAGRAM TO HELP PROPERLY DIAGNOSE A FAULTY FUEL SYSTEM CONTROL MODULE. 1. CONNECT PIN1 (BLACK GROUND) TO PIN16 (PINK GROUND) 2.
Where is the fuel pump control unit located?
Depending on the vehicle, the fuel pump control unit must be taught in the engine control unit. To improve the start behaviour, the fuel pump is often triggered for a few seconds when the driver door is opened, causing pressure to build up in the fuel system – even though the ignition is still switched off.
Where is the fuel pump control module located?
The fuel pump control module is responsible for supply and regulation of voltage to the fuel pump relay and the fuel pump. In most cases, the fuel pump controller is integrated into the PCM but it may also be a stand-alone module. The fuel pump provides pressurized fuel for the fuel injection system. It is most often located inside the fuel tank.
AT THE BOTTOM OF THIS PAGE, YOU WILL FIND THE YOUTUBE VIDEO FOR THIS PROCEDURE. YOU WILL ALSO FIND THE PIN OUT DIAGRAM FOR THE FUEL SYSTEM CONTROL MODULE FOUND ON 2007 AND NEWER GM VEHICLES. PLEASE REFERENCE THE DIAGRAM TO HELP PROPERLY DIAGNOSE A FAULTY FUEL SYSTEM CONTROL MODULE. 1. CONNECT PIN1 (BLACK GROUND) TO PIN16 (PINK GROUND) 2.
THIS WILL POWER THE PUMP TO RUN AND CHECK FOR A FAULTY FUEL PUMP. 3. NEXT, CHECK FOR FUEL PUMP SIGNAL AT THE FUEL SYSTEM CONTROL MODULE. 4. FIND THE DARK GREEN/WHITE WIRE IN PIN13. WITH A TEST LIGHT CONNECTED TO THAT WIRE, TURN THE KEY TO THE RUN POSITION.
How does a fuel pump relay control the fuel pump?
The fuel pump relay is usually controlled by the ignition or Powertrain Control Module, and when switched on, will provide current to the fuel pump so that it may function. As the fuel pump relay controls power to the fuel pump, any faults with it can cause issues with the fuel pump,…
