What happens if my remote for my car dies?
What happens if my remote for my car dies?
Automakers know that your keyless ignition may need to work if the fob dies, and the system has been designed to work even with a non-functioning remote. If your keyless entry works with a START button and there’s no mechanical key slot, there’s still a way to start the car. Use the key fob to push the START button.
Why is my Silverado remote not turning on?
I pulled everything out and is still not working. The Security light in the message center flashes when the doors are open, but will turn off when the key is turned on and start right up. Maybe this is the issue??? Hoping someone has an idea what is going on here.
Are there different numbers for the remotes on a 2001 Silverado?
Thanks for your reply, but I got it figured out. Apparently there is two different numbers for the remotes on a 2001 model, depending on the number on the theft/locking module, and not even the dealer can tell which one the vehicle has.
How to deactivate a PassLock on a 2002 Chevy Silverado?
Turn off the ignition and remove the key if the key is already in the truck. Open the Chevrolet door and wait until the Security light stops flashing. This light informs you that someone has recently tried to start the engine without the right key.
Where was the Chevy Silverado 1500 engine shut off?
While driving approximately 50 mph, the check engine indicator illuminated and the engine shut down a few minutes later. The vehicle was towed to dave white Chevrolet (419-885-4444, located at 5880 monroe st, sylvania, OH 43560) where the technician diagnosed and replaced the fuel pump control module.
How to program a Chevy Silverado key fob remote?
Free Key Fob Remote Programming Instructions for a 2002 Chevrolet Silverado (1500, 2500, 3500) 1 Close All Doors CLOSE all doors. 2 Enter Programming Mode – Step 1 INSERT key into the Ignition (DO NOT TURN). 3 Enter Programming Mode – Step 2 PRESS and HOLD the power UNLOCK button on the Driver’s side door.
Turn off the ignition and remove the key if the key is already in the truck. Open the Chevrolet door and wait until the Security light stops flashing. This light informs you that someone has recently tried to start the engine without the right key.
How to turn off keyless entry on Chevy Silverado?
HOLD the LOCK and UNLOCK buttons on the remote at the same time until door locks cycle again. This could take up to 30 seconds. Now REPEAT Step 6 for all additional remotes to be programmed, including working ones. After Step 6 has been performed for all remotes TURN ignition to ON to exit programming mode. TURN ignition to OFF, and remove key.
How to program a Chevy Blazer keyless entry remote?
HOLD the LOCK and UNLOCK buttons on the remote at the same time, up to 30 seconds, until door locks cycle LOCK / UNLOCK to signal successful programming of the remote. REPEAT Step 6 for any additional remotes to be programmed, including working ones. TURN ignition to ON to EXIT Programming Mode.