What does the ABS code c1214 and c1248 mean?

The system relay is commanded ON. The system voltage is less than 8?Volts for 0.23 seconds. The EBCM disables the DRP/ABS/TCS/VSES for the duration of the ignition cycle. The ABS indicator turns ON. The Traction Control indicator turns ON. The DIC displays the Service Stability System message. The EBCM will also set DTC?C1248.

What does the brake light on code c1214 mean?

The EBCM disables the DRP/ABS/TCS/VSES for the duration of the ignition cycle. The ABS indicator turns ON. The Traction Control indicator turns ON. The DIC displays the Service Stability System message. The EBCM will also set DTC?C1248. The red Brake warning indicator turns ON.

When does the EBCM set DTC?c1248?

The EBCM will also set DTC?C1248. The red Brake warning indicator turns ON. The condition for the DTC is no longer present and the DTC is cleared with a scan tool. The EBCM automatically clears the history DTC when a current DTC is not detected in 100?Consecutive drive cycles. The system relay is integral to the EBCM.

When does the red brake warning indicator turn on?

The red Brake warning indicator turns ON. The condition for the DTC is no longer present and the DTC is cleared with a scan tool. The EBCM automatically clears the history DTC when a current DTC is not detected in 100?Consecutive drive cycles. The system relay is integral to the EBCM. The relay is not serviceable.

What to do if you get a c1243 code?

Start by checking the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the C1243 code is 1.0 hour of labor.

How much does it cost to diagnose a c1243 code?

The cost to diagnose the C1243 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

What is the code for anti lock brakes?

Anti-Lock Brakes (ABS) Codes C1214 Brake Control Relay Contact Circuit Open C1215 Brake Control Relay Contact Circuit Active C1216 Brake Control Relay Coil Circuit Open

Where do I find the ABS code on my car?

Anti-Lock Brakes (ABS) Codes C1214 Brake Control Relay Contact Circuit Open C1215 Brake Control Relay Contact Circuit Active C1216 Brake Control Relay Coil Circuit Open C1217 Brake Control Relay Coil Circuit Short to Ground C1218 Brake Control Relay Coil Circuit Short to Voltage C1221 LF Wheel Speed Sensor Input Signal is 0

What does the brake light on ABS code mean?

The ABS indicator turns ON. The Traction Control indicator turns ON. The DIC displays the Service Stability System message. The EBCM will also set DTC?C1248. The red Brake warning indicator turns ON. The condition for the DTC is no longer present and the DTC is cleared with a scan tool.

How does the Electronic Brake Control Module work?

The electronic brake control module (EBCM) controls each solenoid valve by grounding the solenoid. The EBCM controls the pump motor by grounding the control circuit. The pump serves 2?Purposes: